Repair Kit for Atwood Landing Gear Leg
Question:
atwood level need hand crank to assitest to motor. my legs use 4 bolts on two tabs that are welded to the legs. None of the picture look like what I have. The manual that I have received said MPD 71125. Replacement does not seem likely. I think I need to do a rebuild . I would like to start with the worm gear and the drive gear. What parts number.
asked by: Richard
Expert Reply:
Atwood was sold to Dometic a few years back and replacement parts for older landing gear are scarce. We do still have Stromberg Carlson Landing Gear repair kit for the follow jack that will fit, part # LG-146060. For a lead jack repair kit use # LG-146059.
Since repair parts will eventually be unavailable for this landing gear I suggest you consider replacing the setup with a new one such as # RVLG-8HDL which is rated for 8K. A motor kit can be added using part # LC142178.
Products Referenced in This Question
Lippert Venture 5th Wheel RV Landing Gear Motor
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Motor
- Lippert
more information >
Lead Jack Repair Kit for Stromberg Carlson Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hardware
- Repair Kit
- Stromberg Carlson
more information >
Follow Jack Repair Kit for Stromberg Carlson Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hardware
- Repair Kit
- Stromberg Carlson
more information >
Landing Gear Set w/ Handle - 36-1/2" Lift - 8,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 7001 - 8000 lbs
- Landing Gear
- Sidewind Jack
- 36 Inch Lift
- Weld-On
- 2 Jacks
- etrailer
more information >
Product Page this Question was Asked From
Replacement Lead Jack w/ Drop Leg for Stromberg Carlson Landing Gear - 29-1/2"
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Driver Leg
- Stromberg Carlson
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Wiring
- Shop: Blaylock EZ Lock Trailer Coupler Lock for 1-7/8", 2", and 2-5/16" Couplers - Aluminum
- Q&A: Replacement RV Microwave for Apollo Microwave AAC24OTRB
- Shop: Trailer Hitch
- Shop: Replacement MaxxAir Roof Vent Manual Lift Operator
- Video: Blaylock EZ Lock Trailer Coupler Lock Review
- Shop: Curt Tri-Ball Trailer Coupler Lock for 1-7/8", 2" and 2-5/16" Ball Couplers
- Shop: Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers - Rear Axle
- Shop: Brake Controller
- Search Results: 88138
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Furrion Built-In RV Microwave - 900 Watts - 0.9 Cu Ft - Black
- Search Results: 75234
- Search Results: gnxa2000
- Search Results: 2061
- Q&A: Solution for Needing Replacement Parts for Atwood Levelegs
- Q&A: Replacement Motor/Operator Parts for a Ventline Ventadome V2119
- Q&A: Replacement Power Center For a Magnetek Model 80
- Search Results: 59496
- Search Results: rvk3700
- Search Results: pintle
- Video: Review of Blaylock Industries Trailer Coupler Locks - Surround Lock - BLTL-33
- Video: Air Lift Vehicle Suspension - Rear Axle Suspension Enhancement - AL88138 Review
- Video: Air Lift LoadLifter 5000 Ultimate Rear Air Helper Springs with Internal Jounce Bumpers Review
- Q&A: Are Replacement Parts for Atwood Landing Gear Available or Will Another Brand Fit
- Q&A: Recommended Replacement For Atwood MPD 71125 Landing Gear
- Q&A: Solution for Needing Replacement Landing Gear for 2013 Starcraft Travelstar 278 BHS w Atwood 71125
- Video: Rebuilding the etrailer and Ram Square Jacks
- Video: Lippert Components Trailer Jack LC179013 Review