Can PSI Be Set and Will Air Lift WirelessONE Compressor System # AL25980 Maintain it

Question

Question:

Does this unit automatically kick on when the pressure falls below preset psi? And if so, does it do it when the truck is not running wouldnt want the battery to run down? My truck sometimes sits in storage for 2 to 3 months.

asked by: Brendan F

0

Expert Reply:

The Air Lift WirelessONE Compressor System # AL25980 that you referenced is designed to kick on when needed to maintain a pre-set air pressure that you pick. This won't turn on unless the vehicle is turned on so it would not continue to run in storage or parked overnight.

expert reply by: Jameson C

0

Answer 1

When wiring up the Air Lift WirelessONE Compressor System for Air Helper Springs - Remote and Mobile App #AL25980EZ the power wire needs at least 15 amps to power the unit and the keyed power source that runs to the ignition switch circuit needs at…

view full answer...

Answer 2

My technical contact at AirLift confirmed that the minimum pressure setting for triggering automatic re-filling of the air bags by the WirelessONE Compressor #AL25980 can be changed from the typical 5-psi to 10-psi by putting this setting into one of…

view full answer...

Answer 3

If you have the Air Lift WirelessONE Compressor System like part #AL25980 or part #AL25980EZ then you can simply look in the owner's manual for said error code as there should be a chart which references this and provides a suggested solution. I…

view full answer...

Answer 4

The Air Lift WirelessONE compressor system #AL25980 will automatically adjust the air pressure if the air pressure in your air springs falls below the minimum safe level of 5 psi. The system's low-pressure sensor detects the decrease in air…

view full answer...

Answer 5

The Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers part #AL88289 could potentially affect the ride quality in a negative manner if you were to hit a dip or pot hole in the road while unloaded because of the internal…

view full answer...

Answer 6

Thank you for your purchase from etrailer of the Air Lift WirelessONE Compressor #AL25980EZ. The pink wire is an optional ignition source connection and does not have to be hooked up; it will just allow the #AL25980EZ to make adjustments right when…

view full answer...

Answer 7

Sounds like your air bag setup has a slow leak that is causing the compressor system to try and keep up too often. You should take some soapy water and spray on the bag, lines and where it connects to the Air Lift Compressor part #AL74000 to see if…

view full answer...

Answer 8

Airlift recommends using a keyed circuit that's only active when the ignition is turned on, as the system can activate if the vehicle moves (a strong wind could possibly do it) and possibly drain the battery. According to the installation…

view full answer...

Answer 9

The Air Lift WirelessONE Compressor System part #AL25980 will work just fine in very cold climates. However, you will need to either install the system inside the cab of the vehicle or install the system outside the cab and simply use some air brake…

view full answer...

Answer 10

Towing a 5th wheel trailer can definitely put strain on the rear of any truck, even one as robust as your 2021 Ram 2500, so suspension enhancement is always recommended. The best way to level out your Ram is with air bags, and the option that is…

view full answer...

Answer 11

When adding a compressor system like the WirelessONE #AL25980 to your Air Lift LoadLIfter 5000 that feature the braided stainless steel lines you will need to use the included AN to PTC adapter fitting. This fitting will then connect to the nylon air…

view full answer...

Answer 12

The Air Lift WirelessONE Compressor System first generation 25870 and newer #AL25980 that you referenced are both considered water resistant and will handle limited exposure to water. Definitely don't want to submerge it but in most outside…

view full answer...