Install Kit for Trailer Roof Vent

Question

Question:

I cannot find the recommended kit on the website. Supposedly RVIKIT100

asked by: Will

0

Expert Reply:

The install kit you mentioned is no longer available but we do have the LaSalle Bristol Kit # 344270KITW in White or # 344270KITB in Beige that will give you everything needed to install the Ventline Ventadome Roof Vent # V2092SP-29 that you were looking at. This kit includes two 10.1 oz tubes of sealant, a 60 foot roll of butyl tape, 8 wood screws, and 30 sheet metal screws.

I have attached a sample install video that you can also check out.

expert reply by: Chris R

0

Answer 1

If you need hardware to install the MaxxFan Plus Roof Vent part #MA00-04500K I recommend using the Roof Vent Installation Kit part #344270KITW for white or part #344270KITB for beige. These kits come with all the screws, butyl tape, and sealant you…

view full answer...

Answer 2

If you're talking about adding a fan to the Ventline Ventadome Trailer Roof Vent #V2110SP-24 then no, you wouldn't be able to add a fan and would need to purchase a vent that already includes a fan like the Ventline Ventadome Trailer…

view full answer...

Answer 3

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover, you will also…

view full answer...

Answer 4

I walked out to our warehouse and pulled the Ventline Ventadome Trailer Roof Vent, part #V2110SP-24, from our inventory to measure. The outside edge of the vent flange measured approximately 16-1/2 inches square. The actual opening of the vent…

view full answer...

Answer 5

Thanks for the question, I looked into some roof vents for you to check out. **Ventline Vanair Trailer Roof Vent w/ 12V Fan - 6-1/4" Diameter - Smoke #VP-543SP. *Ventline Ventadome Trailer Roof Vent - Manual - 14-1/4" x 14-1/4" - Metal…

view full answer...

Answer 6

I measured the Ventline Ceiling Garnish #VA0445-37 for you. I found the garnish to measure 15-7/8 inches x 15-7/8 inches overall. On the underside, the trim measures 1-3/16 inches wide. The inside dimensions are 13-1/8 on the end farthest from the…

view full answer...

Answer 7

The Ceiling Garnish for Ventline Roof Vent #VA0445-37 has a flange edge to edge measurement of 15-7/8 inches. The top of the garnish on the inside is 13-1/4 inches square and outside edges will be about 13-1/2 inches square but steps out closer to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR is a single zone 3 wire thermostat like the one you are describing. I have attached the wiring diagram for this thermostat and the control box below for your reference.

view full answer...

Answer 10

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...