Which Safety Chain Kit Fits B and W Gooseneck Hitch

Question

Question:

Will these work with a BandW gooseneck hitch?

asked by: Christian D

0

Expert Reply:

For replacement safety chain U-bolts that fit a B and W gooseneck hitch you'd want the part # BW1900-2-1600. The Curt kit part # C113 only fits Curt hitches.

expert reply by: Jameson C

0

Answer 1

U-bolts for gooseneck hitches have springs on them so that the retract down when not in use. U-bolt kit #C113 sounds like it would work for you with the measurements you have provided. The u-bolts are 2 inches wide on center and the springs, washers,…

view full answer...

Answer 2

I spoke with my contact at Curt, and the U-bolts included in the #C113 replacement hardware kit for the Curt Quick Goose 2 measure 3-3/4 inches long by 2-5/8 inches wide. The inside width is 1-1/2 inches. The threaded portion of the bolts measures 1…

view full answer...

Answer 3

The Replacement Safety-Chain U-Bolt Kit, #C113, has u-bolts that are 9/16 inches in diameter, too large to fit through a 3/8 inch opening in a chain link. U-bolts #382144UB have a 3/8 inch diameter.

view full answer...

Answer 4

The Buyers Products Gooseneck Safety Chain U Bolt Kit #337BRB03 has an overall length of 5-5/8 inches and a length of 4-3/4 inches that is below the top of the truck bed. The diameter is .57 inches and the on center measurement is 1-7/8 inches.

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 10

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Which Safety Chain Kit Fits B and W Gooseneck Hitch

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching