Diameter of the U-Bolts in Replacement Safety-Chain U-Bolt Kit, # C113

Question

Question:

I see you have found out what the length and width dimensions are, how about the diameter of the u-bolt? Will it fit thru a 3/8inch chain link?

asked by: Mike T

0

Expert Reply:

The Replacement Safety-Chain U-Bolt Kit, # C113, has u-bolts that are 9/16 inches in diameter, too large to fit through a 3/8 inch opening in a chain link.

U-bolts # 382144UB have a 3/8 inch diameter.

expert reply by: Michael H

0

Answer 1

I spoke with my contact at Curt, and the U-bolts included in the #C113 replacement hardware kit for the Curt Quick Goose 2 measure 3-3/4 inches long by 2-5/8 inches wide. The inside width is 1-1/2 inches. The threaded portion of the bolts measures 1…

view full answer...

Answer 2

The Buyers Products Gooseneck Safety Chain U Bolt Kit #337BRB03 has an overall length of 5-5/8 inches and a length of 4-3/4 inches that is below the top of the truck bed. The diameter is .57 inches and the on center measurement is 1-7/8 inches.

view full answer...

Answer 3

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 4

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 5

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 8

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 9

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 10

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 11

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 12

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Diameter of the U-Bolts in Replacement Safety-Chain U-Bolt Kit, # C113

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching