Front And Rear Anti-Sway Bar and Steering Stabilizer for 2016 Fleetwood Flair On Ford F53 Chassis

Question

Question:

WHAT ARE THE CORRECT KITS FOR A 2016 FLEETWOOD FLAIR 29T 29foot 11 ON A FORD F53 V10 2016 CHASSIS. ARE THEY ALL BOLT IN WITH THE PROPER MOUNTING BRACKETS AND WHAT WOULD THE PROPER BRACKETS BE FOR EACH OF THE THREE KITS FRONT AND REAR SWAY CONTROL PLUS POSI-STEER FROM ROADMASTER FOR A 2016 FORD ON A FLEETWOOD FLAIR 29T

asked by: Michelle E

0

Expert Reply:

I recommend the Roadmaster Anti-Sway Bar part # RM-1139-146 for the 2016 Fleetwood Flair on the Ford F53 Chassis with 16,000 lb GVWR. Everything you need to install the Anti-Sway bar is in the kit. You do not need U-bolts with this kit because it does not install with U-bolts on the F35 chassis as confirmed by Roadmaster.

I recommend the Roadmaster TruTrac Front-Axle sway bar part # RM-TRAC-F550 for the front of the Fleetwood. It also comes with everything you need to install.

The Roadmaster Steering Stabilizer you need is part # RM-RBK22-RSSA. This also comes with the hardware and brackets.

expert reply by: Heather A

0

Answer 1

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 2

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 3

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 4

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 5

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 6

The Tow Ready wiring harness #118571 is rated for 7.5 amps for brake lights and turn signals and 7.5 amps total for running lights. The fuse that goes on the power wire connection to the battery is a 10 amp fuse. The wire gauge of the long 12 volt…

view full answer...

Answer 7

The torque spec for the rear U bolts on your 2019 F53 motorhome are dependent on the size. If you have 3/4 x 16 u bolts (and used a 1 1/8" socket to remove the nuts) then they torque to 250 lb-ft. If the u bolts are 7/8 x 14 (and you used a 1…

view full answer...

Answer 8

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 9

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 10

Actually our etrailer.com brand brake assemblies are rebranded AxleTek assemblies. So we have the 8k left and right assembly set #AKEBRK-8 which is most likely what you need but these are 12-1/4 inch in diameter by 3-3/8 inches wide and attach with a…

view full answer...

Answer 11

Your 265/70R17 size tire is around 31-1/2 inches in diameter. You want to make sure the tire cover you get is large enough and doesn't have to be stretched over the tire. I'd rather have one that's slightly loose than one that tears…

view full answer...

Answer 12

Unfortunately there are no plug-in adapters or harnesses that would allow you to replace the factory 4-way flat trailer connector with a 7-way or a 7-way and 4-way connector on your 2005 Ford F-150. To complete the installation for a brake controller…

view full answer...

Front And Rear Anti-Sway Bar and Steering Stabilizer for 2016 Fleetwood Flair On Ford F53 Chassis

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching