Recommended Rear Anti-Sway Bar for 2016 Nexus Motorhome on International Terrastar Chassis

Question

Question:

Rear sway bar for nexus international terrastar Does the rear sway bar mount in front of the rear axle, I need it to fit in the front of the axle because I have installed an air bag system in the rear of the axle.

asked by: Bennett S

0

Expert Reply:

The Roadmaster Rear Anti-Sway Bar and Axle Plate Kit if you don't have autochains # RM-1179-112-00 is the correct fit for your chassis and if you do have autochains, then # RM-1179-112 is the correct fit. This anti-sway bar will install behind the rear axle, but is designed to work with the air bag system so it does not interfere. I've attached a photo of the installation instructions that clearly show the air bag as well as the fit.

expert reply by: Jason S

0

click to enlarge

Answer 1

You will need the Roadmaster Front Anti-Sway Bar #RM-1179-121 and Rear Anti-Sway Bar #RM-1179-110 for your 2019 Nexus Wraith 33w Super C since it rides on a 2018 International MV607 chassis. The Front #RM67MR and Rear #RM77MR sway bars you found…

view full answer...

Answer 2

For a 2021 Nexus Ghost on a 2020 International MV air ride chassis you would need the Roadmaster Front Anti-Sway Bar #RM-1179-121 for the front and the Roadmaster Rear Anti-Sway Bar #RM-1179-110. If you do not have "Onspot Chains"…

view full answer...

Answer 3

OnSpot Chains are a special tire chain system for snowy weather (pictured below). Basically the sway bar is going to need the same space for mounting as the OnSpot chains so they can't be used together with the #RM-1179-110-00 you were…

view full answer...

Answer 4

You're looking for the Roadmaster Front Anti-Sway Bar #RM67MR, which is a confirmed fit for your 2022 International MV607 Chassis. As for the shocks, we don't currently carry replacements or enhancements that are compatible with…

view full answer...

Answer 5

The Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets #RM47MR typically comes centered and you would only need to make adjustments after installation and testing to see if it continues to pull. If you adjusted it all the way out to where…

view full answer...

Answer 6

There is a suspension enhancement option for your 2021 Entegra Vision XL built on a Ford F-53 chassis, but I verified with the manufacturer that the steering stabilizer only fits if you have at least a 24,000 lb GVWR. You're not out of luck…

view full answer...

Answer 7

Hey Ron, thanks for reaching out! We have two different steering stabilizers for your motorhome on a 2018 Ford F-53 chassis; the Roadmaster Reflex and the Roadmaster Exact Center. The Exact Center was supposed to be an upgrade to the Reflex but after…

view full answer...

Answer 8

Hi there David; we do have truck camper jacks that can work for your F-250 with a lift and large tires. What you can use are camper jacks from Brophy, which have a 17" to 67" lift range, which is the highest possible lift height. There are…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...