Replacement for Armstrong 7.75-14 ST Trailer Tire

Question

Question:

Any suggestions? Cheers

asked by: P D

0

Expert Reply:

The closest match we have to your 7.75-14 tires is going to be a 205/75-14. As long as the wheels you have now are 5 to 6-1/2 inches wide (measured on the inside where the tire sits) then you could use this size. It will be 8.1 inches wide and 26.3 inches tall.

This size is available in different load ranges (capacities) B, C, or D. The load range C, # AM1ST86, is rated for 1,760 pounds at50 psi. And the load range D, # AM10235, is rated for 2,040 pounds at 65 psi.

expert reply by: Jameson C

0

Answer 1

A lot of the older Atwood water heaters have been discontinued, yes. For your replacement I recommend the Atwood RV Water Heater #AT94022 which is a 10 gallon gas/electric unit like you currently have with an automatic pilot. This uses 120V power and…

view full answer...

Answer 2

We carry the following replacement parts for your Atwood RV Water Heater AT94022: Double-Panel On/Off Switch for Dometic Gas / Electric Combination Water Heaters #AT91230. Replacement Door for Atwood RV Water Heaters #AT91385. If you are needing some…

view full answer...

Answer 3

You can replace the Atwood RV Water Heater AT94022 with the Furrion RV Tankless Water Heater #FR93FR, so long as you have the needed space. According to the instructions, which I have linked for you below, this Furrion unit simply requires the…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 7

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 8

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 9

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Answer 10

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 11

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 12

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Replacement for Armstrong 7.75-14 ST Trailer Tire

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching