What Does the PL Error Code Mean on a Tekonsha P2 Trailer Brake Controller, 2004 Dodge Ram
Question:
The Prodigy brake controller installed in my 2004 Dodge diesel truck was showing a P.L. code when the brakes were applied. The trailer brakes were not activating. Where do I start, to find the problem.
asked by: Eric M
Expert Reply:
The PL code on the Tekonsha P2, # 90885, indicates that there is a power loss while you are stepping on the brakes. The first thing I would check is the red wire. Using a circuit tester like # PTW2993, test the red wire when you step on the brake. It should show a signal when you step on the brake and no signal when you release the pedal.
If it does not show a signal, then the connection to the brake switch is no good and you will need to make a new connection. You can also check the stop light fuse to see if it is blown.
Next, check the blue wire, it should show power when you step on the brake and also when you us the manual override. If it does not show power when you step on the brake or sue the manual override, check the black wire connection and the white ground wire connection. The black wire should be connected to a circuit protected battery connection and the best ground for the controller is the negative battery terminal.
If everything is intact and connected properly you could have a problem with the internal circuitry of the brake controller and it will need to be replaced. If the power only goes off of the black wire when you step on the brake, this could indicate either an insufficient ground or an internal problem with the brake controller circuitry.
Products Referenced in This Question
Product Page this Question was Asked From
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: MaxxFan Deluxe Roof Vent w/ 12V Fan - Manual Lift - 4 Speed - White
- Search Results: 182804
- Shop: Trailer Hitch
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: Bulldog Square Jack - Drop Leg w/ Spring Return - Sidewind - 26" Lift - 10,000 lbs
- Q&A: Compatible Replacement for a CR12124 Trailer Grease Seal
- Search Results: k71~180~00
- Shop: Replacement Brake Pads for Dexter Disc Brakes - 10,000 lbs and 12,000 lbs - Semi-Metallic - Qty 4
- Search Results: pintle
- Search Results: ts10056
- Shop: Gen-Y Phantom X Ball Mount w/ Stacked Receivers for 2" Hitch - 6" Drop/4.5" Rise - 7K
- Shop: B&W Tow & Stow Pintle Hook with 2-5/16" Ball - 2" Hitches - 10,000 lbs/16,000 lbs
- Article: Best RV Roof Vents
- Shop: Double Lip Seal for 3,700-lb Marine Hubs
- Search Results: 7650050~03b
- Search Results: e98849
- Search Results: 175020
- Shop: Tailgate
- Shop: Truck Bed Tailgate Assist
- Article: Gooseneck to 5th Wheel Adapters
- Video: MaxxAir RV Vents and Fans - Roof Vent - MA00-05301K Review
- Shop: Brake Controller
- Video: Fastway Flash 2-Ball Mount with Built-In Scale Review
- Q&A: Comparing SumoSprings and Timbren Off-Road Bump Stops for 2023 Toyota 4Runner
- Shop: Suspension Enhancement
- Video: Review of Timbren Vehicle Suspension - Rear Axle Suspension Enhancement - T73MR
- Video: Timbren Active Off-Road Rear Bumpstops Review
- Video: Performance Tool LCD Digital Circuit Tester Review
- Shop: Trailer Wiring
- Q&A: Troubleshooting Error Codes SH and OL on a Tekonsha Prodigy Brake Controller
on Trailer Brake Controller
