How Much Does the RetraxONE MX Tonneau Cover for a 2018 Ford F-350 with 6-3/4 Foot Bed Weigh

Question

Question:

How much does this unit weigh? I have a short bed. Thank You

asked by: Mark

0

Expert Reply:

The RetraxONE MX Hard Tonneau Cover part # RT60383 which is a fit for your 2018 Ford F-350 with the 6-3/4' has a shipping weight of 90 lbs which means the cover most likely weighs around 85lbs. This is going to be the lightest RetraxONE tonneau cover available for your truck. Please keep in mind that this tonneau cover will cover the stake pocket holes. For the exact same tonneau cover but with cutouts for the stake pocket holes you will want to use the RetraxONE MX Hard Tonneau Cover part # RT60386 which also has a shipping weight of 90 lbs.

expert reply by: Conner L

0

Answer 1

Here are some tips we've gotten from MORryde in the past for your situation where the threshold won't let door shut. Verify the distance from the threshold to the front of the StepAbove hinge plate it should be 15/16". There should also…

view full answer...

Answer 2

There is going to be a bit of movement with the kingpin inside of the locking jaws on the B&W Companion OEM 5th Wheel Trailer Hitch part #BWRVK3370 as it does need to rotate while turning but there aren't any adjustments for this. That said,…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The B&W Companion OEM 5th Wheel Hitch w/ Slider for Chevy/GMC Towing Prep Package #BWRVK3775 you're looking at will work fine with your new Chevrolet Silverado. This hitch has 3 height adjustments so you'll be able to set the hitch height…

view full answer...

Answer 8

I spoke with my contact at Trailair and from your serial number we were able to determine that your trailer came with a 1621 HD pin box which is a long pin box style. I was unable to obtain the exact part number for your Trailair pin box but from the…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 11

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

view full answer...

Answer 12

The B and W Patriot slider is the only hitch unfortunately that can't be adapted to fit the OEM rails of your 2024 Ram 2500 as none of the adapters can work with it. So Mike what that means is that no matter how you slice it...it's time for a…

view full answer...