Frame Bolts Used to Install the Draw-Tite Hitch on a 2007 Dodge Grand Caravan
Question:
2007 grand caravan i was going to order this hitch 75305 looked under van and the 12mm frame bolts were missing. I just got this van to tow my camper dealer ha no clue about these bolts. Could you give me any info about the bolt. Yes its a 12 mm i tried some from napa but no go . Any help would be great. Thanks
asked by: Donald
Expert Reply:
As you mentioned, the installation of the Draw-Tite Max-Frame Trailer Hitch Receiver part # 75305 requires that you reuse two M10 and M12 bolts that should already be present in the frame rail. The only information I have on these bolts is just that, the diameter. I unfortunately do not have any additional info that pertains to thread pitch and length.
However, if you speak to the parts rep at the dealer then I am sure they would have this info and a part number for you. I would try to call more than one and make sure you are speaking with a parts rep. If they still are not able to locate this information then you can either go to a hardware store and get a few different M10 and M12 bolts to try or you could just go to the junkyard and snag a few for yourself. Don't forget to bring a breaker bar and lubricant if this is the route you go as they will more than likely be stuck in there pretty good.
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 4000 lbs WD GTW
- 2 Inch Hitch
- 400 lbs WD TW
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: Trailer Wiring
- Video: Trailer Hitch Installation - 2005 Dodge Grand Caravan - Curt
- Q&A: Troubleshooting Frame Weld Nut Broke Off Inside Frame On a 2005 Chrysler Town and Country Receiver
- Q&A: Hitch Recommendation for 2005 Chrysler Town and Country with Stow-N-Go Seating
- Q&A: What Bolts Should I Use To Install A Draw Tite Class 3 Trailer Hitch
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Shop: Excel RV Tankless Water Heater - Gas - Electric Ignition - Vent Free - 38,000 Btu
- Video: Choosing the Right Trailer Wiring
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: How to Choose the Right Trailer Hitch Class
- Search Results: trailer hitch
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Search Results: hitch
- Search Results: trailer hitch wiring
- Shop: Brake Controller
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Recommended Hitch for a 2024 Toyota Grand Highlander
- Video: Choosing the Right Brake Controller
- Shop: 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Search Results: wiring harness
- Article: Trailer Wiring Diagrams
- Q&A: What Hitch Do You Recommend for a 2024 Toyota RAV4?
- Video: etrailer Class III Trailer Hitch Installation - 2024 Subaru Crosstrek
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: Roof Rack
on Trailer Hitch
