Replacement Slide Out Motor for Power Gear Part 520229

Question

Question:

will a 520555 replace a 520229 slide out motor

asked by: Eugene

0

Expert Reply:

If you are needing to replace your Power Gear 520229 slide out motor then the correct replacement motor gear assembly is part # LC386321 from Lippert Components. Since the replacement motor for the Power Gear 520555 from Lippert is part # LC387523 and it doesn't look like the motor in your picture I doubt it is compatible.

expert reply by: Jon G

0

click to enlarge

Answer 1

I contacted the manufacturer, Lippert, about this and they gave me a spec sheet with all of their available information about the Replacement Gear Motor Assembly for Lippert Electric Slide-Out #LC386322, which you can see. This motor operates at 15…

view full answer...

Answer 2

The number you mentioned of 523387 cross references with the Replacement Gear Motor Assembly #LC386322 that you referenced so this would be the correct motor you'd need.

view full answer...

Answer 3

There are two replacement slide out motors available to replace your current 5078-025, one with a connector on the end of the wires and one without a connector on the end of the wires. If you do not have the connector then you will need the…

view full answer...

Answer 4

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 6

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 7

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 8

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 9

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 10

I really wish we had replacement parts still for the Atwood couplers but since they've been out of business for so long we don't have any way to get the parts you are wanting.

view full answer...

Answer 11

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 12

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Replacement Slide Out Motor for Power Gear Part 520229

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching