Compatible Power for ThermaHeat RV Holding Tank Heater Pad

Question

Question:

Is this heating pad dual power as in it can run on 120v and 12dc?

asked by: Brent J

0

Expert Reply:

The ThermaHeat RV Holding Tank Heater Pad w/ Thermostat # 277-000163 is compatible with 12 volt DC power but can be used with a converter to adapt to AC power. This pad is designed to be used on holding tanks with capacities between 29 and 40 gallons and simply sticks onto your tank.

expert reply by: Kyle S

0

Answer 1

The ThermaHeat RV Holding Tank Heater Pad, Item #277-000164, will need to be connected to a 12 volt power source. You should be good to go and you just need to follow the installation instructions for safety and security. I have attached a short…

view full answer...

Answer 2

The only tank that actually requires a heating pad is the freshwater one because the other tanks you can simply pour RV antifreeze into and not have to worry about heating the tanks. That said if you wanted to you could install Thermaheat pads like…

view full answer...

Answer 3

The Quickie Flush RV holding tank rinser #CAM40123 provides a straight stream and does not spin. For one that does provide a 360 degree spray I recommend #CAM40126.

view full answer...

Answer 4

The good news is that you don't have to have heaters on black and gray water RV tanks. The fresh water needs a heater as you can't put any antifreeze in it. But since you don't have to worry about poisoning the water in the…

view full answer...

Answer 5

With gray water tanks you can simply pour a couple quarts of RV antifreeze down the drain of a shower and toilet and you'll prevent them from freezing. Since you don't want to drink antifreeze that's why the heaters are typically only…

view full answer...

Answer 6

I went out into our warehouse and grabbed a part #CAM40126 to take a couple pics of the install instructions for you to check out. I attached them to this page.

view full answer...

Answer 7

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

view full answer...

Answer 8

We have two options for you to use an adapter with your 12V accessory with a 110V outlet. They are the AC to DC Adapter for Swift Hitch Wireless Camera System, part #PP01, and the Power Converter for Fan-Tastic Vent Endless Breeze Portable Box Fan,…

view full answer...

Answer 9

The 25" x 7-1/4" Heater Pad with Thermostat for RVs #277-000163 will only produce heat when attached to a power source. If you disconnected the power source it would turn off. 12 volts is DC power though. You would need an inverter if you…

view full answer...

Answer 10

I reached out to my contact at Five Star Manufacturing (the maker of Kat's Heaters), and he confirmed that the 25-watt Kat's Heaters Oil or Transmission Pan Heating Pad 1-1/2" x 5" - 120V #KH24025 gets to about 150 degrees…

view full answer...

Answer 11

Yes you can use the AC to DC Adapter for Swift Hitch Wireless Camera System part #PP01 to get your 115 AC power down to the 12V power that you require for your Furrion monitor to work. As an alternative and more permanent type of fix for this you can…

view full answer...

Answer 12

You may splice your generator into the main 12V power and ground from the trailer's 7 pin connector to power the interior lights if you use an inline fuse like part #SWC9538 and fuse part #C58450-1 between the 7-pin 12V wiring and the generator…

view full answer...

Compatible Power for ThermaHeat RV Holding Tank Heater Pad

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching