Diameter of the Spigot on the Valterra RV Sewer Elbow Part # T1035-2

Question

Question:

Can the 3” spigot end be installed directly into the black tank? Is the O.D. The correct size?

asked by: John

0

Expert Reply:

The outer diameter (O.D.) of the end opposite the flange on the Valterra RV Sewer Elbow part # T1035-2 measures 3-7/16" therefore if the inner diameter (I.D.) of the outlet on your black water tank is 3-7/16" then it will work for you. If not you would need to purchase an adapter at your local plumbing store. In order to attach the pipes I recommend using the Valterra ABS Solvent Cement part # A05-0303.

expert reply by: Conner L

0

click to enlarge

Answer 1

To ensure that your spindle is not sticking out of your hub farther than it should, I would recommend verifying that all of your bearings and seals are seated correctly and the hub is tightened down correctly. When tightening the hub to the…

view full answer...

Answer 2

I do have a solution for you, however the Draw-Tite QSP Trailer Hitch Silencer and Cover for 2" Hitch Receivers #63080 is specifically designed to work with Draw-Tite 2" x 2" trailer hitch receivers. Because the collars on…

view full answer...

Answer 3

The #UF48-979002 feature oversized footplates that are 4-1/2" wide by 9" long, so you could use them without leveling blocks. However, it's not uncommon for people to use leveling blocks like #A10-0918 or even wooden blocks…

view full answer...

Answer 4

From the flange of the Valterra RV Sewer Elbow #T1035-1 out to the furthest point out on this measures 5-1/2 inches.

view full answer...

Answer 5

We do carry some Lippert Hydraulic jacks but none by those part numbers. I tried looking them up on Lipperts site and found nothing on the 2571254 number and the 25712510 seems to have been superseded by a jack with a 14,000 lb. capacity, but not one…

view full answer...

Answer 6

For your 2018 Ram 1500 with a 5-1/2 foot truck bed we have the Reese custom fifth wheel rail kit part #RP50142-58 as a confirmed fit that would work great. Since it's a custom install kit it would install without frame drilling and is perfectly…

view full answer...

Answer 7

The length from the rotating flange to the edge with the bayonets on the RV Sanitary Reducing Tee - 3" Lug x 3" Rotating Flange x 1-1/2" Hub #T1011 is 4-1/4".

view full answer...

Diameter of the Spigot on the Valterra RV Sewer Elbow Part # T1035-2

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching