Recommended In-Bed 7-Way Wiring Harness for Slide in Truck Bed Camper on 2011 Ford F-350

Question

Question:

I want to install a wiring harness to accommodate a slide in truck camper. I have a 2011 F-350 6 3/4 foot box. Will this work?

asked by: Troy

0

Expert Reply:

Unless you specifically need the 9 foot length provided by the part # 50-97-410 harness you referenced, I would recommend the Pollak 5th Wheel / Gooseneck T-Connector, part # PK11893-11932.

The Pollak harness is 7-1/2 feet long, and with a short bed truck it should be more than long enough at half the price.

I have linked to a video showing a typical installation. The video shows a different vehicle, but should provide you a good idea of how to proceed with the install.

expert reply by: Mike L

0

Answer 1

Your slide-in truck camper does not have electric brakes so the blue brake circuit wire from its 7-way connector is not used. All other lighting functions as well as 12V auxiliary power will be maintained on the other circuits. Please refer to the…

view full answer...

Answer 2

The Jensen Stereo #JWM60A most likely needs to be reset. The connections you mentioned are most likely causing issue if I understand correctly because you will only be able to use one input signal at any given time. If you are using the USB input,…

view full answer...

Answer 3

Both the Jensen JWM6A and the current model, part #JWM62A are classified as double-DIN head units, which will both use the same sized rough openings in a vehicle dash. The old #JWM6A and the current model #JWM62A both use the same pigtail, as you can…

view full answer...

Answer 4

There is not a plug and play adapter for your Lance connector that we are aware of. Typically this is installed by the Lance dealer. A junction box/7-way plug kit like #HS381-9000 is an option you have to convert the camper to match the 7-way RV…

view full answer...

Answer 5

I recommend using the Adapter #47515 or #20036 and not connecting the extra blue wire to anything on the truck. On a 5-Way flat connector, the extra blue wire is normally for an electric reverse lockout which you find on a lot of boat trailers. The…

view full answer...

Answer 6

Most likely what you would need is the part #30717. This has a 4-way on one side of the connector that would get plugged into your Explorer and 7-way connector on the other side for connecting to your trailer. This 7-way is a 7-way blade style…

view full answer...

Answer 7

10 feet is the longest 5th wheel style of 7-way harness that we offer. If you can find a more direct route to get it up to the front of your truck bed that would be ideal. Otherwise we do have 7-way extensions you could use on the camper like…

view full answer...

Answer 8

Trailer hitches are rated in two ways. The most common rating is weight carrying. This rating is for towing a trailer with a standard ball mount that transfers all of the trailer tongue weight to the towing vehicle. The second rating is weight…

view full answer...

Answer 9

For your 2017 Hyundai Santa Fe XL Limited I recommend starting with the Curt Trailer Hitch Receiver 2" #C13153. This will give you a strong hitch and will allow your spare tire to be reinstalled without any issues. For your wiring, I recommend…

view full answer...

Answer 10

The "with/without board or step underneath truck bed" designation is referring to whether or not a step or nerf board runs underneath the truck bed. If you have these and they don't extend beyond the cab then you would choose the…

view full answer...

Answer 11

The TorkLift #TLC2205A and #TLC3205A Talon camper tie-downs will work great with your 2005 Silverado 2500 if it isn't equipped with running boards or tube steps that run under the truck bed and is equipped with the factory hitch. The only other…

view full answer...

Recommended In-Bed 7-Way Wiring Harness for Slide in Truck Bed Camper on 2011 Ford F-350

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching