Troubleshooting Trailer Wiring Install on 2010 Jeep Wrangler Unlimited Where Only One Side Worked
Question:
So I purchased the rugged ridge towing harness and when I hooked it up to the left taillight only one side worked, when I tried hooking it up to the right side my blinkers on the trailer went off on the opposite side from the Jeep! What do I need to do to have them work properly
asked by: Sheena
Expert Reply:
First thing you should do at this point is test the 4-way of the wiring harness with a circuit tester part # PTW2993 for voltage on all of the right pins when the taillight signals are being applied. Just like in the video I attached.
If the voltage checks out there but the trailer lights still don't function right then the problem is on the trailer wiring. That would mean that problem is either due to a ground issue or a short issue.
Make sure that the trailer side connector are clean and free of corrosion inside and out. The main connector grounds should be attached to clean and corrosion free bare metal surfaces. The light grounds should also be attached to clean and corrosion free bare metal surfaces. If there is anything between a light ground and the metal trailer frame or if the trailer has an aluminum frame, tilt bed, or folding tongue, any of these things can interrupt the ground. Running jumper wires from the light grounds to the main trailer connector ground can help.
If the problem is on the vehicle side then I would first recommend you double check how the harness is installed on your vehicle, make sure all of the connections are good and tight. You should check all towing related fuses and relays as well.
Products Referenced in This Question
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Can Tekonsha Harness and Hopkins Towed Vehicle Wiring Kit be Used on 2017 Jeep Wrangler Unlimited
- Search Results: 7 way connector
- Search Results: 4 way to 7 way adapter
- Search Results: tailgate
- Shop: EZ Connector Magnetic 5th Wheel/Gooseneck Custom Wiring Harness w/ 7-Way Connector - Watertight Seal
- Shop: Wire Loom, 1/2" Diameter (per Foot)
- Shop: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 7-Way Trailer Connector
- Shop: Curt Trailer Connector Adapter - 4-Way to 7-Way RV and 4-Way Flat
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Mighty Cord 5th Wheel/Gooseneck Wiring Harness w/ 7-Way Connector - 10' Long
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Shop: Trailer Hitch
- Search Results: 44649
- Video: Choosing the Right Trailer Wiring
- Search Results: 25580
- Video: Choosing the Right Brake Controller
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: Brake Controller
- Shop: Fifth Wheel Hitch
- Q&A: Recommended Components for Off-Road Trailer Similar to Chevy Colorado Wheels
- Article: How to Choose the Right Trailer Hitch Class
- Video: Tow Ready 4-Pole Mounting Bracket Installation
- Search Results: 68149
- Video: Titan Trailer Brakes T2385200 Review
- Shop: Gooseneck Hitch
- Q&A: Trailer Grease Seal to Replace 127194TB