What is Overall Diameter of Karrier ST235/85R16 Radial Trailer Tire # AM10501

Question

Question:

I need to know the tire height.

asked by: Jim C

0

Expert Reply:

The overall diameter of the Karrier ST235/85R16 Radial Trailer Tire # AM10501 that you referenced is 31.6 inches.

expert reply by: Jameson C

0

Answer 1

The wheels you have now will have no problem with the PSI of 110 that you mentioned but the valve stems might depending on what's in there now. Best option will be to order new valve stems with the tires that have the higher pressure rating like…

view full answer...

Answer 2

The standard offset for trailer wheels is zero to keep the load on the trailer centered on the tire. The Karrier ST235/85R16 Radial Trailer Tire with 16 inch White Wheel - 6 on 5-1/2 - Load Range E, item #AM32764, comes with a 0 inch offset wheel, is…

view full answer...

Answer 3

Changing to a larger diameter radial tire from a smaller bias ply type can offer several advantages. In general radial trailer tires run cooler than bias ply tires, especially when the tire is under a load. A tire that runs cooler will last longer. A…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 7

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 8

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 12

You can add larger wheels and tires to a trailer as long as you have enough room for the larger size. The main clearance issues we find when putting larger tires and wheels on a trailer is from the top of the tire to the fender and from the inside…

view full answer...