Availability of Sendel T02 Machined Trailer Wheel with an 8 on 6-1/2 inch Bolt Pattern

Question

Question:

Do you have the same wheel or similar as AM22653 in an 8 bolt? I have a 2016 Jayco Pinnacle.

asked by: Paul S

0

Expert Reply:

Yes, we have the part # AM22662 which is the same style of wheel as the part # AM22653 except has a bolt pattern of 8 on 6-1/2 inch and has a diameter of 16 inch.

expert reply by: Jameson C

0

Answer 1

The type of power inverter needed for a refrigerator would be pure wave. In regards to the correct size, this will come down to the starting amps/watts required for the refrigerator. The Everchill RV Mini Refrigerator part #324-000109 for example…

view full answer...

Answer 2

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 5

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 6

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 7

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 8

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...