Locating Replacement Bearings for Load Rite Utility Trailer Model UT58
Question:
I am trying to find replacement bearings for a Tie down engineering Axle model#50150A on a Load Rite Utility trailer Model UT58. Thanks for your time. Cheers,
asked by: Paul H
Expert Reply:
In order to locate the correct replacement bearings for your Load Rite trailer, I recommend simply pulling the hubs and checking for the bearing numbers that should be stamped inside the bearings themselves. If you cannot locate the numbers, you can also take a few measurements along the trailer spindle with a digital caliper like # PTW80157. I have attached an image that clarifies where the measurements will be taken.
Unfortunately, trailer manufacturers don't often keep a good record of the smaller parts like bearings that they install at the factory, so this is still the best method for determining the correct parts.
With this in mind, I did do some research on your UT58 model and found that it features a 3,500 pound axle. If this is the case, most likely the hubs will use # L68149 for the inner bearing and # L44649 for the outer bearing, but it is still a good idea to check your existing hubs just to be sure.
Products Referenced in This Question
Replacement Trailer Hub Bearing - L44649
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.063 Inch I.D.
- Bearing L44649
- Race L44610
- 3500 lbs Axle
- etrailer
more information >
4" Carbon Fiber Digital Caliper
- Hand Tools
- Measuring and Layout Tools
- Digital Calipers
- Carbon Fiber
- Performance Tool
more information >
Product Page this Question was Asked From
Replacement Trailer Hub Bearing - L68149
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.378 Inch I.D.
- Bearing L68149
- Race L68111
- 3500 lbs Axle
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Fulton Single Axle Trailer Fenders w Top and Side Steps - Silver Plastic - 14" Wheels - Qty 2
- Shop: Yakima DeckHand Kayak Roof Rack w/ Tie-Downs - Saddle Style - Clamp On
- Shop: Yakima DeckHand Kayak Roof Rack w/ Tie-Downs - 1/2 System - Saddle Style - Clamp On
- Shop: Wesbar Wishbone Wiring Harness with 4-Pole Flat Trailer Connector - Trailer End - 18" Long
- Q&A: Why Does 4-Pin Trailer Wiring Have 5 Wires
- Shop: CE Smith Front Hanger Bracket for Trailer Slipper Springs - Galvanized Steel - Bolt On - Qty 1
- Shop: CE Smith Single Axle Trailer Fender - Gray Plastic - 8" to 12" Wheels - Qty 1
- Shop: Mounting Bracket for 6-1/2" Oval Trailer Tail Light - Black
- Video: Buyers Products Trailer Lights 337LB1 Review
- Search Results: trailer light bracket
- Search Results: 44649
- Q&A: Hub And Drum Replacement for 90865 Rockwell Hub and Drum
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Search Results: 68149
- Video: Choosing the Right Trailer Wiring
- Article: Trailer Tire Sizing
- Shop: Trailer Wiring
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Search Results: dust cap
- Q&A: Replacement Clearance Lights Needed for GLO-BRITE 122R and 122Y Lights
- Shop: Brake Controller
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Gooseneck Hitch
- Search Results: 25580
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Article: Most Popular Wheel Bearings
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Q&A: Recommended Components for Off-Road Trailer Similar to Chevy Colorado Wheels
- Shop: Fifth Wheel Hitch
on Trailer Bearings Races Seals Caps
