Is there a 50 Amp Rated Generator Adapter

Question

Question:

Do you carry a 50 amp power cord for a portable generator?

asked by: Art T

0

Expert Reply:

We do have some generator adapter cords rated for 50 amps:

Cord # A10-G30450VP is a 50 amp female to 30 amp male twist lock
Cord # A10-50X30Y is a Y-Cord with a 50 amp male plug and two 30 amp female plugs
Cord # CAM55412 is a 125 volt 30 amp twist lock male and 50 amp female

expert reply by: Michael H

0

Answer 1

12 KW converted to amps at 125 volts is 55 amps and the Mighty Cord part #A10-5025EDBK is only rated for 50 amps. So while your generator can put out more amperage than needed it would come down to whether or not your entire house would draw more…

view full answer...

Answer 2

For your generator, I recommend the Mighty Cord Generator Adapter for RV Power Cord - 50 Amp Female to 30 Amp Twist Lock Male - 12" #A10-G30450VP and then the Power Grip 90-Degree Locking Marine-Style Power Cord Adapter - 50 Amps -…

view full answer...

Answer 3

We do not have a wiring diagram available but I did reach out to my contact at Mighty Cord and was able to verify that both the hot legs on the Generator Adapter #A10-G30450VP are fed from the 30 amp side of the adapter. I have attached a short video…

view full answer...

Answer 4

For the 3 prong 30 amp outlet on your generator, I recommend using the Power Grip Generator 30 Amp to 50 Amp RV Power Cord Adapter #CAM55412. The 3-Prong twist-lock design will connect with the outlet on the generator and the female end will connect…

view full answer...

Answer 5

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

You can use the RV Propane Gas Detector #RS64FR to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 11

Yes, in order to set your trailer up for use with shore power you will first need an AC distribution panel. For this, I recommend a Progressive Dynamics Series AC Distribution Panel. In order to bring power into the panel you will also need a power…

view full answer...

Answer 12

The 15,000 Btu Furrion air conditioner is what I would recommend and what I have on my trailer. Since it is an enclosed trailer I'm guessing you want the manual distribution box. You can choose from the following based on color: -Furrion Chill HE…

view full answer...

Is there a 50 Amp Rated Generator Adapter

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching