Recommended Brake Controller and Harness for Winnebago Brave Motorhome
Question:
I have a 2004 p53 winnebago brave and I want to install your prodigy p 3.... where does it plug into? It looks like theres a grey plug under the dash that might be it, but it isnt marked as a trailer brake connector. Also what adapter cord would I need? Thanks.... if you have a photo plese send it
asked by: James
Expert Reply:
For your 2004 Winnebago Brave, you have a Ford F53 chassis and can absolutely use the Tekonsha Prodigy P3 # 90195. You will be able to use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers # 3035-P which will connect to your factory wiring on the left side under the dash. It sounds like you have found the correct harness and it will not be labeled. I've attached a video to assist.
Products Referenced in This Question
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Ford, Lincoln, Mercury
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Product Page this Question was Asked From
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Brake Controller
- Video: Pollak Wiring - Trailer Connectors - PK12703 Review
- Shop: Roadmaster Tow Dolly with Electric Brakes - 4,250 lbs
- Shop: Ventline Exterior Wall Vent for RV Range Hood - Locking Damper - 1-3/4" Collar - Black
- Shop: Ventline Exterior Wall Vent for RV Range Hood - Locking Damper - 1-3/4" Collar - White
- Shop: Brophy Swiveling D-Ring Anchors w Backing Plates and Hardware - Bolt-On - 2,000 lbs - Qty 4
- Shop: Backing Plate for RR06 Recessed Swivel D-Ring Tie Down
- Shop: Vehicle Tow Bar Wiring
- Shop: Blue Ox High-Low Adapter for Tow Bars - 2" Hitches - 10" Rise/Drop - 11-1/2" Long
- Search Results: brake controller wiring
- Shop: Base Plate for Tow Bar
- Shop: Brass Battery Terminal Bolt Extender - Long Side Terminal - 3/8"-16 Thread x 1-13/16" Long
- Search Results: bal 7.3 leveling system
- Search Results: 7 pin connector
- Search Results: trailer brake controller
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Must-Have Flat Towing Components
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Using a Backing Plate for D-Ring Placement on a Trailer
- Q&A: Is Supplemental Braking Really Needed When flat Towing a 2017 Jeep Cherokee
- Article: Flat Towing Package for 2005-2007 Jeep Liberty
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: 4 way flat trailer connector
- Search Results: 4 pin 5 wire
- Shop: Trailer Hitch
- Shop: Vehicle Tow Bar Brake System
- Shop: Trailer Wiring
- Video: Brophy Swiveling D-Ring Anchor with Backing Plate and Hardware Installation - Enclosed Trailer
- Video: Choosing the Right Brake Controller
- Q&A: Should the Blue Trailer Connector Wire be Hot All the Time
on Trailer Brake Controller
