Recommendation to Convert Generator Power to 12V 7-way Trailer Connection

Question

Question:

Hello, i have a enclosed trailer where when at the track wed like to power the lights inside the trailer but dont want to drain the battery on the truck, we have a generator that produces a 12v dc output. That being said would i be able to take a 7 pin trailer plug and attach a 12v plug to it to connect to the generator?

asked by: Ryan

0

Expert Reply:

Generators do not typically have a 12 volt power converter, so I recommend using the Battery Charger and Maintainer # CTEK56353 and splicing the connector that would go to the battery terminals into a 7-way connector like # 30717. You will connect the black end of the charger wiring to the white wire of the 7-way and the red wire of the charger wire to the black wire of the 7-way. This will give you the 12V power to your trailer from your generator through the trailer plug connection.

You may want to consider mounting the 7-way to your generator frame using # 18138 to keep it off the ground and prevent moisture or connection issues.

expert reply by: Jason S

0

Answer 1

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 2

It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…

view full answer...

Answer 3

The Optronics Flexible LED Light Strip part #UCL90CB would be the best option for adding LED strips to the inside of an enclosed trailer. The strips can be cut to fit you exact needs and they feature a simple two wire design. The wires could then be…

view full answer...

Answer 4

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 9

Hey Dustin, thanks for reaching out! I will recommend SumoSprings over Timbrens all day everyday because they are much more forgiving when the vehicle is unloaded. We've actually joked around here about how the Timbren kits will either give you…

view full answer...

Answer 10

The air bag kit I recommend going with to fit the Adaptive Ride Control on your 2022 GMC Sierra 1500 Limited is the Firestone Ride-Rite Air Helper Springs #F2609. Even though there are a limited amount of air bags that fit your vehicle, the Firestone…

view full answer...