Weight Distribution System Chain Hanger Recommendations for Reese Weight Distribution System  

While snap up brackets like the Replacement Hook Up Brackets for Curt Weight Distribution Systems #C17208 are somewhat interchangeable, I would still recommend using like branded brackets. The Pro Series weight distribution hitches are manufactured…

What you are looking for is the snap up handle #RP58162 which we have confirmed with Reese/Pro Series as being the correct handle you'd need. The head and picture you sent in a picture of is the Pro Series RB2 part #58333.

You would not want to tighten the nuts of the Curt Weight Distribution Replacement Lift Chain U-Bolts part #C17111 to the point that the link isn't able to move anymore. You will want to allow the chain to move in the U-bolt. The reason the…

The spring bars are interchangeable on the Pro Series round bar weight distribution systems. The 1,200 lb replacement spring bars that you will need are part #58338. This is a single bar, so you will want to order a quantity of 2. These bars will…

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The…

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…