Can LED Light Bulbs be Used in Gustafson RV Vanity Light

Question

Question:

Can LED bulbs be used with this fixture? If so, what type of base? Thank you.

asked by: Jim G

0

Expert Reply:

Gustafson RV Vanity Light - Satin Nickel - 3 Light Item # 277-000319 takes three 9019 bulbs such as # 277-000321. If you can find LED bulbs in the 9019 base you can use them but unfortunately we don't carry anything compatible at this time.

expert reply by: Michael H

0

Answer 1

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 2

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Answer 3

There should be 2 inches minimum between the tires on a dual axle trailer. This will allow the suspension components room to work properly but a little more room is ideal. For instance the Ultra-Fab Chock and Lock Wheel Stabilizers for Tandem-Axle…

view full answer...

Answer 4

Yes, you will need the Thule universal change key, #853-1251, to remove and install new lock cores. the change key pulls down all the tumblers so the lock can be removed or inserted. The existing lock, if present, will have to be unlocked for the…

view full answer...

Answer 5

Lippert Carpet Protectors for RVs with Slide Outs #LC134993 do not permanently install though you could leave them where you place them if you want. A slide-out generally slides on 2 rails below the floor of the slide-out room. That is where the most…

view full answer...

Answer 6

If you look at the brackets of the TorkLift HiddenPower Under-Vehicle Battery Mount #TLA7727 you'll see that the top hook goes much wider than the bottom one. There wouldn't be a frame dimension that this will work with since trailer frames…

view full answer...

Answer 7

There is a suggested and common method for 6 function trailer wiring. You will have the following functions: Right Turn, Left Turn, Ground, Tail/marker, Brake, Battery. I have included a help article on trailer wiring that includes a diagram and…

view full answer...

Answer 8

For a standard replacement equalizer for your Dexter 13-122 equalizers you'd want the #TREQE1 or for a cushioned version you'd want the part #K71-653-00 which comes with new shackles and bolts. For a kit that includes new bolts, bushings, and…

view full answer...

Answer 9

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 10

A 16 inch tire will not fit on a 16.5 inch wheel. You would either need to get new 16 inch wheels with the proper bolt pattern to match what the hubs require or to get your existing wheels you would need to go with 16.5 inch tires. You mentioned you…

view full answer...

Answer 11

If the two 6 volt batteries were wired in series to produce 12 volts total then a 12 volt battery would easily work as a replacement for them. If the two batteries were wired in parallel and the output voltage is 6 volts then no. I attached a diagram…

view full answer...

Answer 12

From our experiences the Harbor Freight trailers like yours have a hub bore that requires a cap or Bearing Buddy that measures 2.047 inches like the #BB2047 you referenced. We don't have a standard cap that fits this size so the Bearing Buddy is…

view full answer...

Can LED Light Bulbs be Used in Gustafson RV Vanity Light

Products Referenced in This Question

Continue Researching