Replacement Fuse Holder or Circuit Breaker for Use with Stromberg Carlson Electric Jack JET-5000

Question

Question:

need the inline30 amp breaker switch for the jet 5000

asked by: Larry T

1

Helpful Expert Reply:

You can use either a fuse holder such as Spectro # SWC9545 along with a locally-sourced mini fuse, or you can use a 30-amp auto-resetting circuit breaker # PK54230 to protect the circuit that powers your Stromberg Carlson Electric Trailer Jack # JET-5000.

expert reply by: Adam R

1

Answer 1

For your electric jack, there are only three possible explanations for your jack not working with a charged battery. Either power is not getting to your motor, your motor is bad, or your ground connection isn't working properly. To test power,…

view full answer...

Answer 2

Once an overload condition has ceased then the circuit breaker should reset itself. It is mounted on the outside of jack #UF38-944017 but should not need any persuasion to reset. If the jack is not powering on it could be that an overload or short…

view full answer...

Answer 3

One of the 3/8 inch ports is open on the Valterra RV Water Tank #R8030 and is plugged by the red cap like you see in the accompanying photo; this is where the tank would be filled. You would not want to modify the opening to fill up the tank, instead…

view full answer...

Answer 4

Pintle hitches are made to fit certain sized Lunette rings. The rings that we carry are only available in 2-1/2" or 3" diameter sizes. For example, the Curt Pintle Hook for 2" Hitches #C48004 fits lunette ring couplers with a minimum…

view full answer...

Answer 5

From the center of the tube to the furthest part of the motor housing on the Stromberg Carlson Electric Trailer Jack item #JET-5000 measures right at 5-3/4". The distance from the mounting bracket to the top of the jack is 23". This jack…

view full answer...

Answer 6

From the center of the jack tube to the outside edge of the head cover on the Bulldog Powered Drive Trailer Jack #BD500199 is 4",and the head cover extends out 1" from the edges of the jack tube. I've attached some diagrams for you to…

view full answer...

Answer 7

Hey Gilbert, The right air spring kit for your 2023 Ford F-150 4WD is going to depend on if your model has Continuously Controlled Damping (CCD) suspension or Onboard Scales option as well as if you have a PowerBoost hybrid engine. If you have CCD…

view full answer...

Answer 8

What tire size do you have now? What is your wheel bolt pattern?

view full answer...

Answer 9

The Stromberg Carlson Electric Trailer Jack part #JET-5000 is a great option for you that would work well and would replace your current jack easily. This jack has more capacity AT 5000 pounds. This allows the jack to work less and consequently last…

view full answer...

Answer 10

The mounting plate on the Stromberg Carlson Electric Trailer Jack #JET-5000, is 23 inches below the top of the motor housing. Check out the attached video.

view full answer...

Answer 11

You will need a 12V battery for the Stromberg Carlson Electric Trailer Jack Part #JET-5000. The amperage draw for this jack at full load is 25-amps, so that is what I would want to know when shopping for a battery.

view full answer...