Roof Rack for 2007 Fleetwood Westlake Pop-Up Camper

Question

Question:

Im trying to find a rack for my 2007 Fleetwood Westlake. I just want something that is supposed to work with it since i only want to screw into the roof once.

asked by: Sam

0

Expert Reply:

There are a pair of options to get a roof rack on your 2007 Fleetwood Westlake Camper. The SportRack Pop-Up Camper Roof Rack # SR1020 has a weight capacity of 200 lbs, and can adjust from 80", 83" or 86" long while measuring 1-1/4" wide x 1-1/4" tall. Please keep in mind this rack will not fit roofs that have a curved or rounded edge, and the roof must have a maximum width of 85-1/2".

The other option to add a roof rack to your Fleetwood is the Swagman Roamer LT Roof Rack for Pop-Up Campers # S80510. This rack has a weight capacity of 150 lbs with dimensions of 84-5/16" long x 1-3/16" wide x 1-3/16" tall. It's fit restrictions are that it is not designed for use with plastic, 1-piece trailer tops.

I've included installation instructions for both racks so you can take a look.

expert reply by: Kyle S

0

Answer 1

The SportRack Pop-Up Camper Roof Rack #SR1020 will fit your 2007 Fleetwood Bayside pop-up camper with 78 inch wide rails on the roof. And while there is a way to install this roof rack without drilling, it requires your camper roof to have tracks…

view full answer...

Answer 2

In order to use a weight distribution/sway control (WD/SC) system it is necessary to have room on the trailer A-frame to mount the spring bar lift brackets and the hitch on the tow vehicle must specifically be rated for use with WD/SC systems. The…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 8

Yes, the Roamer LT Roof Rack for Pop-Up Campers and Camper Shells #S80510 will fit your 2023 Forest River Flagstaff 176LTD. It is also what I recommend to add a roof rack for a bicycle carrier on your camper. Once installed you will be able to add…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

Hey Jeremy, Typically with boat trailers the manufacturer will install hydraulic surge brakes because you don't have to worry about the water damaging wires like you would with electric brakes. That being said, if you use a heat shrink butt…

view full answer...

Answer 11

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 12

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...