Replacement Roof Vent Cover for Lid Marked AS-13M-VDO449 ANS Z26 1

Question

Question:

Hi, I need to replace my Vent cover. The numbers are AS-13M-VDO449 ANS Z26 1 Can you help me out with that? Thank You

asked by: Richard S

1

Helpful Expert Reply:

We have had a similar question to this come up and we were able to determine that the number AS-13 M-VDO449 that you listed is stamped on the vent cover part # BVD0449-A01.

If you are looking for the entire fan setup and not just the cover you would want the part # V2092SP-28 for a white lid or part # V2092SP-29 for a smoked lid. The smoked lid would allow more light in.

expert reply by: Jameson C

1

click to enlarge

Answer 1

To pair the camera and monitor parts of your Furrion Vision S observation camera system #FOS43TASF you can try pressing the button on the bottom of the camera. Please refer to the linked photo. First disconnect power to both camera and monitor…

view full answer...

Answer 2

Most likely we have what you are looking for but you will need to first determine what vent you have on your trailer. In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly…

view full answer...

Answer 3

Based on my research, the 57915.303 model number you mentioned in your question refers to the Dometic Briskair air conditioner unit. If this is the case, then the Adco Air Conditioner Cover #290-3021 should fit perfectly. This cover features…

view full answer...

Answer 4

If your current awning is a 16 foot awning you can use this replacement #LCV000334402. This is compatible with Solera, Dometic A&E, and Carefree of Colorado awnings. Dometic A&E make the Sunchaser Awning Model #834AV18.401

view full answer...

Answer 5

Thanks for that photo, and I checked with Go Power and you will need a solar panel compatible with your Go Power Solar on The Side, from Go Power. I verified with them that the panel you will need to connect to this is the panel you mentioned as it…

view full answer...

Answer 6

Per Dexter your axle will need the Grease Seals #RG06-070. We also have the Bearing Kit #BK3-300 that will provide you with new wheel bearings, races, a grease seal and cotter pin. I recommend having one or 2 of the bearing kits with the trailer in…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

view full answer...

Answer 12

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover,…

view full answer...

Replacement Roof Vent Cover for Lid Marked AS-13M-VDO449 ANS Z26 1

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching