Yakima Roof Rack Components Needed to Install Roof Rack in Camper Top Channel

Question

Question:

I have tracks on my pop up trailer for sliding racks. Will these yakima style work are the track systems pretty universal?. Ive included an image of the tracks that are on my 2007 Feetwood Cheyenne pop up camper.

asked by: Eric H

0

Expert Reply:

The landing pad you would need is part # Y00221 which will fit your roof rack channels. For towers you need two of the part # Y00152 and a round bar adapter part # Y03536.

For 58 inch crossbars you would want part # Y00409.

For 78 inch long you'd want the part # Y00411.

expert reply by: Jameson C

0

click to enlarge

Richard A.

4/15/2020

Would this work on a jayco 1207ud that has a similar rack system? Would this support a hobie pro angler that weight around 100lbs?

Reply

Chris R.

4/16/2020

Those tracks on your Jayco's roof are designed for crossbars systems like this, so the Yakima setup Jameson mentioned above will work on your camper as well. The roof rack itself has the capacity needed for your boat, but you may want to verify the weight limit of the roof with Jayco just to be safe.

Reply

Answer 1

The screws included with the installation hardware for the SportRack Pop-Up Camper #SR1020 are self-tapping screws. Self-tapping screws are actually designed to have a pilot hole slightly smaller than the screws, even though they're not…

view full answer...

Answer 2

If you check out the video I attached to this page you'll see a general guide for removing the screen of a roof vent in the the first minute of the video. This process is basically standard amoung trailer roof vents so this process will be…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 5

Thanks for reaching out, Joe! I recommend using the Rhino-Rack Aero Bar Roof Rack for Camper Shells #Y02-480B which comes with 63" long tracks as well as 54" long crossbars which should give you a little bit of overhang on your…

view full answer...

Answer 6

The Rhino-Rack Heavy-Duty Roof Rack Roof Rack have specific C-channels that are designed to fit specific Rhino-Rack Heavy-Duty accessories, like the Rhino-Rack Hi-Lift Jack and Shovel-Holder Brackets #RRRCB-RSHB-RJHB as an example. That's…

view full answer...

Answer 7

The Rhino-Rack Roof Rack for Factory Tracks #Y02-490B-NT is going to be your best bet for the tracks on the ARE topper for your 2012 Toyota Tacoma. The weight capacity is 220 lbs like you mentioned, but that's going to be the highest you'll…

view full answer...

Answer 8

According to Rhino Rack, if you were to go with the shorter bars, you'll only have 1-1/4 inch of leeway on each side which isn't enough in their opinion. I'd recommend going with the 71 inch bars so you'll be certain of a good fit. As…

view full answer...

Answer 9

The Rhino-Rack Aero Bar Roof Rack for Camper Shells part #Y02-480B is a great option for fiberglass truck bed campers as it was made for this exact purpose. It can support up to 220 lbs but bear in mind this rating is tested independently of the…

view full answer...

Answer 10

Yes, the Roamer LT Roof Rack for Pop-Up Campers and Camper Shells #S80510 will fit your 2023 Forest River Flagstaff 176LTD. It is also what I recommend to add a roof rack for a bicycle carrier on your camper. Once installed you will be able to add…

view full answer...

Answer 11

Yes. You will need to use everything included with the Rhino-Rack Roof Rack for Thule and Yakima Tracks - 2 Heavy-Duty Crossbars - Black - 65" #Y01-140B-NT to install into the tracks you have pictured. The bases of the legs mount right into the…

view full answer...

Answer 12

Hey Alex, it sounds like you are looking for just the tracks of the Rhino Rack camper shell roof rack kit #Y02-480B which we do offer with the part #RTC16.

view full answer...

Yakima Roof Rack Components Needed to Install Roof Rack in Camper Top Channel

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching