Replacement Bearing Kit for 2000 Viking Pop Up Camper with L44649 Inner and Outer Bearings

Question

Question:

I have a 2000 Viking pop up camper, MOdel number is 2107. it is rate 2000 pd axle and made by Dexter. The maual says the inner is L44610/L44649 and outer is the same as above, could you now tell me what kit I need?

asked by: Tom

1

Helpful Expert Reply:

If both your inner and outer bearings are # L44649 then the correct replacement kit is # BK1-150.

expert reply by: Charles S

1

click to enlarge

Answer 1

To determine the correct bearings for your trailer hubs you will need to supply some more information. The more information you can find, for the list below, the more likely we will be able to find the correct parts. Part numbers form the inner and…

view full answer...

Answer 2

Since you most likely have the hub off of your trailer you will want to measure the spindle of your trailer where the seal ride to verify that the included seal of the #BK1-150 will fit your setup. If that diameter is 1.50 inches and the outer…

view full answer...

Answer 3

The Dexter Trailer Springs Over-Under Conversion Kit #K71-384-00 that you referenced is designed for 2-3/8 inch diameter axles which is normally used on 3,500 lb axles. You most likely have a smaller axle diameter than this like either 1-1/2 inch…

view full answer...

Answer 4

The best way to determine the replacement bearings needed on your 2011 StarCraft 1019 pop-up camper is to remove one of the wheels and then the hub and look for the number printed on the inner and outer bearing as well as the seal of that hub. Those…

view full answer...

Answer 5

You will want to inflate the tires to the max psi that the tires have listed on the sidewall. Trailer tires always need to be inflated to their max pressure to ensure you get their full capacity whereas the max psi rating for a wheel is just how much…

view full answer...

Answer 6

For your Dexter torsion axle that has a 2,000 lb capacity the correct lift kit is the part #K71-723-01 for each axle. This will give you a lift of 2-5/8 inches.

view full answer...

Answer 7

To replace the 4.80-12 size tires on your 2005 Viking Pop Up Camper, I recommend looking at the Taskmaster #AM30660. This 4.80-12 bias tire is mounted to a nice 12 inch white spoke wheel that has a 5 on 4-1/2 inch bolt pattern. The tire itself…

view full answer...

Answer 8

Since you do not need the trailer brake or 12 volt charging functions when towing your pop-up, you would be able to cut off the 6-Way square connector currently on your Viking Pop-up and use a 4-Pole Trailer End Connector, item #18004, to connect to…

view full answer...

Answer 9

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 10

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 11

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 12

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...