Winch to Replace Shelby Model 5351 Winch

Question

Question:

We have the winch on our new grain bin to raise the truck spout. We just used it for the 1st time and cant get it to lower. The handle just wants to unscrew from the shaft

asked by: DJ

0

Expert Reply:

There is no longer a repair kit available for the Shelby 5351 brake hand winch.

A reliable option to replace it is Fulton 1500-lb winch # F143100 along with 25-foot cable # DL24100.

I have linked our main page for all brake hand winches that will allow you to select a new one with the capacity you need. Jut click on the filters on the page to choose singe- or two-speed operation and your preference for a wire rope or strap. The linked help article that will guide you to the best winch for your application.

expert reply by: Adam R

0

Answer 1

I do have a solution for you, but it will not include replacing a wheel on your existing winch. Your Shelby Winch, model 5351, is a 1,000 lbs winch with a 2-way ratchet. If you need to replace your existing winch I recommend a winch by Dutton…

view full answer...

Answer 2

The Shelby winch part #5351 that you mentioned is no longer available but it was a 1,000 lb winch with a 2 way ratchet. Dutton Lainson actually bought Shelby so the most similar winch would probably be the Dutton Lainson part #DL14934 which is a…

view full answer...

Answer 3

To secure a cable on the Dutton-Lainson Worm Gear Winch - 1,500 lbs, #DL11011, you will use a series of loops around the reel and gear. You will not need to use a cable fastener or cable keeper to do this. I have attached a diagram that shows how the…

view full answer...

Answer 4

Installing a brake controller on your 1989 Chevy Silverado pickup is pretty straight forward. To start, you will need all of the parts for the complete installation of a trailer connector and the brake controller. The parts needed are a 4-Way trailer…

view full answer...

Answer 5

If the lift motor will no longer operate with the controller but does when you apply direct 12 volt power then that tells me there is an issues with the control board. The only way to replace the control board on the Fan-Tastic Vent Roof Vent part…

view full answer...

Answer 6

If you are wanting to use a drill to ease operation of the winch, the Dutton-Lainson #DL11011 would be a much better choice. This winch is specifically designed so that the handle is easily removable for use with a drill. Using the shaft directly…

view full answer...

Answer 7

The instructions for the #DL11011 state, "to minimize heat build up and possible winch damage, do not exceed 600 rpm." So, although you can use a drill with the Dutton-Lainson Drill Drive Socket Adapter for DLB Series Winches #DL6456 to…

view full answer...

Answer 8

To secure a cable on the Dutton-Lainson Worm Gear Winch - 1,500 lbs, #DL11011, you will use a series of loops around the reel and gear. You will not need to use a cable fastener or cable keeper to do this. I have attached a diagram that shows how the…

view full answer...

Answer 9

For a worm gear winch that you can use with a strap instead of a cable I recommend #DL11002. You could then use strap #DL24242. You will need to add the hex shaft, #DL406102, in place of the standard shaft to use a variable speed drill with the…

view full answer...

Winch to Replace Shelby Model 5351 Winch

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching