Dimension Of Epicord 30 Amp Power Inlet

Question

Question:

What size diameter hole is required to install. I have seen the QandA on mounting screw location/size and outside dimensions but not the center hole size. Thank you.

asked by: Dave

0

Expert Reply:

I went out into our warehouse to measure the Epicord 30 Amp Twist Lock Power Inlet - White # 277-000137 for you. The hole needed is a 3 inch diameter and it is 2-1/4 inches recessed into the wall. I've attached a photo to help.

expert reply by: Jason S

0

click to enlarge

Answer 1

We checked with Dexter and P-21 just indicates where the axle was made. With the serial number we could track down more info on your axle. However, in the mean time you could pretty easily get the bearing numbers off of your current bearings and then…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

The 15,000 Btu Furrion air conditioner is what I would recommend and what I have on my trailer. Since it is an enclosed trailer I'm guessing you want the manual distribution box. You can choose from the following based on color: -Furrion Chill HE…

view full answer...

Answer 4

The 1" Long Black Torx Wall Liner Screw #WLS100 is the best option for the plywood installation. These screws are fine thread and made for metal studs. They have a tapping edge but often a starter or pilot hole should be drilled. You can then…

view full answer...

Answer 5

We do have the exact replacement you need for your Dexter 008-249-07 hub, with the complete kit, which includes the hub and drum, bearings, race, and grease seal being the following part: - Dexter Trailer Hub and Drum Assembly for 3,500-lb Axles…

view full answer...

Answer 6

We do offer a direct replacement for the Shelby 5101 A-Frame Trailer Coupler, it's the A-Frame Coupler part #CA5100B for black or part #CA-5100-Z for zinc. These couplers both have a 5,000 lb weight capacity with 2" hitch ball. In order to…

view full answer...

Answer 7

Based on my research the Shelby 5101 is an A-frame coupler with a 2" ball and 5,000 lb capacity. We have exactly that with the A-Frame Coupler #CA5100B, which has a trigger latch and has a black paint finish. The same coupler is available with a…

view full answer...

Answer 8

I did a Google search on the information you found on your brake drums and wasn't able to find anything conclusive regarding a replacement. We offer one 10 x 2-1/4 inch brake drum with a 5 on 5 bolt pattern, part #84556UC3 for a standard or…

view full answer...

Answer 9

We have a great option in a replacement 45 amp power converter for your ELX-45. I suggest the Progressive Dynamics, #PD4045KA. This is a 2-in-1 AC/DC distribution panel and smart charger that works with lithium-ion, flooded lead acid, AGM, and gel…

view full answer...

Answer 10

The mounting holes on the Epicord 30 Amp Twist Lock Power Inlet #277-000137 are 2-7/16 inches apart vertically and horizontally. Externally it measures 3-5/16 inches wide x 3-3/4 inches tall x 3-1/4 inches deep. The picture I attached shows the…

view full answer...

Dimension Of Epicord 30 Amp Power Inlet

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching