Recommended Heavy Duty Shackles for Tandem Axle Trailer

Question

Question:

Im replacing the springs on a 2 axle trailer. They both have 1/4 inch thick shackles. Are there any other ones with thicker shackles so they are more durable?

asked by: Mick

0

Expert Reply:

We do have some more heavy-duty type shackle kits and for that I recommend one of the following from MORryde based off of the length of your shackles:

- 2-1/4" Shackles # MR58ZR
- 3-1/8" Shackles # MR76ZR

The shackles that come with these kits are 1/2" thick so they will be much more durable than your current shackles.

expert reply by: Jon G

0

Answer 1

I reached out to MORryde and the MORryde Rubber Equalizers for Tandem Axle Trailers - 35" Wheelbase - 8K #MR27ZR you were looking at is designed for 35" axle spacing and would not work with your trailer with 36" axle…

view full answer...

Answer 2

I contacted MORryde and this does happen from time to time as the weight of the trailer can spread out the axles due to downward pressure on the springs/suspension. Odds are the 35" wheel base #MR27ZR will be the correct one for you, but…

view full answer...

Answer 3

The hangers you currently have on your trailer are ones I have run into before. That being said, I spoke with MORryde and the #MR27ZR will still fit your trailer, but there is a modification that will need to be made. You’ll have to trim according…

view full answer...

Answer 4

Hey Patrick, so for your leaf spring upgrade I am going to need to know a couple of things before I can get you over to the right part. Specifically, the length from eye to eye, the spring width, leaf thickness, and the number of leaves. From here…

view full answer...

Answer 5

You will measure the MORryde Suspension Upgrade Kit for Tandem Axle Trailers #MR76ZR from the center of each hole on the shackle strap.

view full answer...

Answer 6

You will definitely want to go with the Road Armor Shock Absorbing Equalizer Kit #LC696740 over the MORryde as the Road Armor has more travel and will provide a smoother ride. Then, in regards to shackle straps I'm not sure what you mean by…

view full answer...

Answer 7

Finding the correct MORryde equalizer kit will be pretty specific, so I cannot tell you which will be correct without knowing the wheel spacing and axle capacity, unfortunately. With that being said, if you have the trailer's VIN, you may be…

view full answer...

Answer 8

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is…

view full answer...

Answer 9

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have…

view full answer...

Answer 10

I can help you figure out how to determine the best option for a wet bolt/shackle upgrade kit, though in order to determine the correct one you will need to take a quick measurement of the shackle straps on your Jayco Jay Flight. The reason for…

view full answer...

Answer 11

Hey Mike, To determine if the MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR would be a compatible fit you'll first want to measure the bolt hole spacing on your current equalizers. The #MR87ZR has a 6-1/2" center to…

view full answer...

Answer 12

Trailer manufacturers don't usually keep a record of parts like these that they install at the factory, so I cannot be sure as to the exact length of the shackle strap that would have come originally on your trailer. With this in mind, a…

view full answer...

Recommended Heavy Duty Shackles for Tandem Axle Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching