How to Pick Out JT Strongarm Stabilizer Kit for 2016 Keystone Outback 324CG

Question

Question:

I have a 2016 Keystone Outback 324CG with electric front and back stabilizer jacks that come down. Not scissors jacks! Will the JT Strongarm Stabilizer Kit work on those?

asked by: Mark C

0

Expert Reply:

The correct JT's Strong Arm Jack Stabilizer Kit for your 2016 Keystone Outback 324CG depends on the landing gear on the trailer. You will want to measure the distance between the legs of the landing gear on your trailer to select the correct JT's Strong Arm kit. If there is over 58 inches between the landing gear, you will want part # LC191023 that you referenced.

If there is less than 58 inches between the landing gear, you will want part # LC191024.

expert reply by: Jameson C

0

Answer 1

Hi Darin, Yes you can mount the brackets to the inside of your I-beam when installing the JT's Strong Arm Jack Stabilizer Kit #LC191023. Just be sure when measuring to install the brackets you mark the distance at that point instead of the…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 4

The Ark Drop Down Corner RV Stabilizer Jacks #ARK94FR are able to lock into place at 30 and 60 degrees as stabilizers. They also have the 90 degree position where it is rated for 1,929 lbs and then the stored position.

view full answer...

Answer 5

I contacted the manufacturer about the lengths for these stabilizer jacks and have included the information they were able to provide me. The Ark Drop Down Corner RV Stabilizer Jacks #ARK34FR are 422 mm (16.6") collapsed and 600mm (23.6")…

view full answer...

Answer 6

The Lippert High-Speed Power Stabilizer Jack part #LC298707 would be an excellent replacement option for the now discontinued 337199 model. It does come with a new switch so you can either wire this up or reuse the existing, either way the switch…

view full answer...

Answer 7

For your Lippert Components Power Stabilizer Trailer Jack #LC298707 the wiring is pretty simple. There are two wires that come out of the motor and they are both used as power or ground depending on the direction you want to turn the motor. To…

view full answer...

Answer 8

I have included a picture showing how the motor and switch wire up on the Lippert stabilizer jack #LC298707.

view full answer...

Answer 9

I have included a picture showing how the motor and switch wire up on the Lippert stabilizer jack #LC298707.

view full answer...

Answer 10

You made a great choice in the Lippert Components Power Stabilizer Trailer Jack. For starters, all of the jacks measure to be 70-1/2" long with a 3,500 lb weight capacity and have a 30" lift. The difference between them is in regards to…

view full answer...

Answer 11

I attached a picture that shows the install instructions for the Lippert Components High-Speed Power Stabilizer Jack #LC298707 that you referenced and in it you'll notice a set distance isn't specified for where it has to install on the…

view full answer...