Sumosprings Recommendation for 2000 Ford F-350

Question

Question:

I recently purchased a F2550 airbag kit from you and it does not work on a 2000 f350 dually, since my truck has factory sway bars. I am now looking at the sumosprings. My camper loaded is 4,000lbs. In addition to this I have a boat that adds 600lbs of tongue weight which is not including the 24inch hitch extension. Is the 5000 lb sumosprings enough capacity? Will it work with my factory rear sway bars?

asked by: Ronald K

0

Expert Reply:

The SumoSprings Rebel Springs part # SSR-101-47-2 will be a great option for your 2000 Ford F-350. It will give you an additional 5,000 lbs of suspension support which help and work well for your setup.

I checked out the install instructions for this kit (which are attached) and it would not interfere with the sway bar at all.

expert reply by: Jameson C

0

Answer 1

The RoadActive Suspension #RAS3611-HD will definitely fit your 1995 Ford F-350. This includes models with dual rear wheels. However, installing this will require permanent removal of the top overload springs as this will essentially replace them.…

view full answer...

Answer 2

Yes, the correct RoadActive Suspension Heavy Duty kit for your 2001 Ford F-350 Super Duty is part #RAS3611-HD, which fits single and dual rear wheel models regardless of cab size. Just note that if your truck has factory overload springs (located…

view full answer...

Answer 3

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 4

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 5

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 8

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 9

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 10

I can definitely help you find the correct replacement hub and bearings for your Dexter P-12 SLR axle, but since part of the serial number was unreadable you will need to take a few simple steps to identify which bearings your axle uses. The easiest…

view full answer...

Answer 11

According to my contact at Fantastic Vent the correct replacement lift motor to use in your vent is part #FVK6010-81, not item FVK-6050-80. The replacement motor does operate at a higher 17-RPM speed. Since your fan is of a lower rpm and manufactured…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Sumosprings Recommendation for 2000 Ford F-350

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching