How Much Does Enclosed Trailer Ramp Spring CB250D96SHD Weigh

Question

Question:

What is the approximate weight of the Enclosed Trailer Ramp Spring - Dual, 96inch Wide, Part Number CB250D96SHD?

asked by: Bob E

0

Expert Reply:

Enclosed Trailer Ramp Spring # CB250D96SHD weighs approximately 45 pounds. I have included a link to a video review of this spring for you.

expert reply by: Michael H

0

Answer 1

I checked with M-3 and when you are ready to wind the spring on the Enclosed Trailer Ramp Spring #ERS120D81 you will need to use two 1/2 inch diameter bars (of around 18 inches long). You will insert the first bar into the winding cone of the…

view full answer...

Answer 2

You did not mention what specific dimensions you were looking for, so I took several. I then produced a pictured showing the measurements. The blue arrow indicates the center to center distance between the mounting holes. The green arrow is center…

view full answer...

Answer 3

What you can do is use Enclosed Trailer Ramp Spring - Dual Spring, 81" Wide #ERS120D81 which will work for doors which go down to 62 inches wide. You can take a look at the video review of this product I've added for you.

view full answer...

Answer 4

You will need to measure to be sure, but I believe the Enclosed Trailer Ramp Spring - Dual Spring, 81" Wide #ERS120D81 will fit your 18 foot Haulmark Trailer and I've included the dimensions of this hit for you. Each spring is 22-1/2…

view full answer...

Answer 5

I found a trailer ramp spring that will work for you application. The Enclosed Trailer Ramp Spring, #ERS120D81, that has a measurement of 71-5/8 inches from cable roller to cable roller. The overall length is 81 inches long. The attached picture…

view full answer...

Answer 6

Normally the trailer ramp springs like the #362SA5 attach to the inside of the top of a trailer door like the picture I attached shows. In the picture you can also see how it attaches to the ramp as well.

view full answer...

Answer 7

Unfortunately, we don't offer the torsion springs as an individual item. I'd recommend the #M384FR 6-foot spirng assembly which includes the shaft, drums, cable and all the needed hardware for installation. Keep in mind, those torsion springs…

view full answer...

Answer 8

You won't need to obtain the weight of the entire door, just the un-hinged side. You'll want to find the amount of weight you'll need to overcome to easily lift the door. You could use an old bathroom scale, place some blocking on it, and…

view full answer...

Answer 9

The cable that comes with the Conventional Ramp Door Spring for 8' Wide Enclosed Trailer - Dual Spring - 150-lb Capacity #362SA8207 is 150" and can be replaced with part #CAB1-8CB150. I confirmed this with my contact at TRC. If you needed to…

view full answer...

Answer 10

The spring assemblies are pretty universal and can be cut to length depending on what size you need. The Conventional Ramp Door Spring for 7' Wide Enclosed Trailer - Dual Spring - 120-lb Capacity item #ERS120D81 will work for your Carry-On…

view full answer...

Answer 11

A ramp door spring rated for 4k in/lbs of torque is going to offer more assistance than a ramp door spring rated for 2k in/lbs of torque. However, choosing the highest rated door spring available is not in your best interest. If the spring was rated…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...