Location of Brake Controller Install Harness In 2013 Winnebago Adventurer 37F

Question

Question:

HI, Can you tell me where to look for the harness and what connector I would need for the above. I think I see it on side of steering column, but it doesnt look like a 3034 -p connection. My class a coach is on a f-53 frame. Thanks

asked by: Stephen W

0

Expert Reply:

According to the Q-206 bulletin released by Ford the correct harness for your F-53 is the # 3034-P you referenced.

The harness the # 3034-P connects to is a port under the dash behind the instrument cluster. It's not easy to get to but it's there. Check out the picture I attached to see where it is.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The correct install harness for the Prodigy P3 Brake Controller part #90195 for your 2013 Ford F-53 motorhome chassis is the part #3035-P. The connector is located on the left hand side of the steering column support.

view full answer...

Answer 2

Hey Scott, If you're wanting a brake controller that will plug into your factory wiring harness and won't give you any errors then I recommend going with the Tekonsha Prodigy P3 #90195 along with the Tekonsha Plug-In Wiring Adapter…

view full answer...

Answer 3

The correct replacement key for your etrailer Hitch Receiver Lock #e98881 with key code 029 would be Replacement Key for etrailer Hitch and Coupler Locks #e75UR.

view full answer...

Answer 4

Thanks for all the details Jason! To get a Blue Ox tow bar to fit with the shackles on your 2021 Jeep Wrangler Sport you'll need either the 7/8" #BX88357 or 1" #BX88358 Adapters, but just be sure to check with the manufacturer of your…

view full answer...

Answer 5

The controller for the Brake Buddy Stealth #HM39530 can be purchased with part #HM39533. This is the only component that ties into the motorhome besides the 7-way cable #HM39532. I've attached a wire diagram below to help aid you during the…

view full answer...

Answer 6

I would be happy to help you find the right connector. It is behind the dash at the very top of your console on your 2019 Ford E-350. You will need to pop that panel out and the connector you are looking for will be plugged into the insert. I have…

view full answer...

Answer 7

The 2017 Chevrolet Equinox has a brake pedal sensor which makes it difficult to locate and use the stop light switch to install our #ETBC7 kit. You'll need to access the BCM (body control module) under the dash which will likely be near the…

view full answer...

Answer 8

It sounds like you are on the right track for tracking down where the issue is. That said, the integrated brake controllers they were putting in trucks around 2008 weren't as reliable as the ones they've been installing since then. Especially…

view full answer...

Answer 9

The connector for attaching the brake controller is clipped to the back of the storage tray located in the dash, under the climate controls. To access the connector, remove the tray and unclip it from the rear of the tray. If you have the OEM wiring…

view full answer...