Thickness of Shackle Strap part # TRSL350

Question

Question:

How thick is the steel?

asked by: John

0

Expert Reply:

The thickness of the shacke part # TRSL350 is 1/4 inch.

expert reply by: Jameson C

0

Answer 1

There is no specific torque rating for shackle bolts. Basically for the middle bolt there should be enough free play in the shackles to allow them to move. Tightening the shackle bolts too much will squeeze the shackle straps against the leaf…

view full answer...

Answer 2

There is no set angle, but you want to leave enough room for the suspension to articulate. By looking at the photo, you will indeed need to move the rear hanger back a bit. The shackle strap be much closer to vertical, as shown in the diagram…

view full answer...

Answer 3

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 4

To determine if hanger kit #APT5 will fit your trailer you will need to look at the measurements in the picture I have provided and compare them to how the trailer is set up now. There are no installation instructions. The hangers get welded to the…

view full answer...

Answer 5

The threaded portion of the bolts of the #K71-403-00 are 7/16 inch but the stepped up diameter is 9/16 inch. The shackle length is 3-1/8 inch from hole center to hole center. The bolt length is 2-7/8 inches. We can't help much with the axle…

view full answer...

Answer 6

The Dexter Single Axle Heavy Duty Suspension Kit #K71-403-00 uses the Shackle Bolt #007-126-01. The 9/16" portion of this bolt is 2-1/4" long.

view full answer...

Answer 7

It sounds like the axles were attached with 2 inch U-bolts that are 1/2 inch diameter which are a standard size so it sounds like the axles are compatible with a standard U-bolt kit like the CE Smith U-Bolt Kit for Mounting 2" Square Trailer…

view full answer...

Answer 8

The Dexter Single Axle Heavy Duty Suspension Kit #K71-403-00 technically will not have a torque specification. However, I have been asked this before and was informed by Dexter that what you need to do is tighten them down to the point of either…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Thickness of Shackle Strap part # TRSL350

Product Page this Question was Asked From

Continue Researching