Will Aries Nerf Bars Fit a 2015 GMC Sierra 2500 Diesel with DEF Tank

Question

Question:

Are these bars compatible with the DEF tank on the passenger side? Also do they require a vertical lip on the underside of the truck to drill through? Mine is completely flat

asked by: Mike

0

Expert Reply:

Aries nerf bars # AA204045 attach to the rocker panels on your 2015 GMC Sierra 2500. Drilling is not required for installation. The brackets use mounting locations already present on the vehicle, see instruction link. There are special brackets that are included for diesel models to avoid interference with the DEF tank. This is mentioned in the instructions in step 10 and on.

expert reply by: Michael H

0

Answer 1

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 4

Yes, the TrackTowers part #Y52AV does fit into Yakima HD tracks like what you have installed on your trailer.

view full answer...

Answer 5

There are a couple of options that'll work great with your Lippert Turning Point Pin Box, however one hitch stands out to me more than others. Take a look at the: -Curt E16 5th Wheel Trailer Hitch - Slide Bar Jaw - 16,000 lbs #C16115 This 5th…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

Aries nerf bars #AA204045 attach to the rocker panels on your 2015 GMC Sierra 2500. Drilling is not required for installation. The brackets use mounting locations already present on the vehicle, see instruction link. There are special brackets that…

view full answer...

Answer 8

This will depend on if you have disc or drum brakes on your triple axle boat trailer. Disc Brake Kit #HS381-9067 Drum Brake Kit #HS381-9066 Each kit contains the correct electric over hydraulic actuator, 7-way wiring and breakaway components. If you…

view full answer...

Answer 9

Hi Jeff; thanks for the question and sturdy is definitely a good word for the etrailer tonneau that fits your 2022 Ram 1500 with a 5-1/2 foot bed, the etrailer Hard Tonneau Cover #e35DR. It's made of a fiberglass-reinforced plastic which is a…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Thank you for the photos and sorry to hear about your truck! The unique design of the B&W Tow & Stow 2-Ball Mount - Compatible with GM MultiPro Tailgate #BWTS20066BMP is that angled section that meets with the shank part of the ball mount. On…

view full answer...

Answer 12

Normally trailer coupler height is around 17 inches, from the ground to the bottom of the coupler, and most hitch manufacturers design their hitches to work with a ball mount that will end up very close to this measurement. I am including a link to…

view full answer...