Roof Rack Fit for 2012 Kia Soul with Naked Roof

Question

Question:

I have a 2012 Kia Soul Base Station Wagon/4 cylinder/2 axles/fuel G and just wish to know if the SR1002 will fit. Thank you!

asked by: Carl

0

Expert Reply:

For your 2012 Kia Soul with a naked roof you would want the Rhino Rack roof rack part numbers # RRVA126B-2, # RRRLKVA and # DK237 which is a confirmed fit. The SportRack part # SR1002 is not a confirmed fit for your vehicle so we can't recommend it.

expert reply by: Jameson C

0

Answer 1

You'll need to install a roof rack on your 2010 Kia Soul to carry a roof cargo basket. Since you have naked roof currently you'd want the Rhino Rack roof rack part numbers #RRVA126B-2, #RRRLKVA and #DK237. With this rack installed…

view full answer...

Answer 2

If your 2022 Chevy Colorado ZR2 is four-wheel-drive with a N (Neutral) and a Four-Wheel Drive Low setting then it can be flat towed. To flat tow your Colorado you'll need a tow bar, base plate, tow bar wiring kit, braking system, and safety…

view full answer...

Answer 3

When picking out a fairing you want to go with the length that matches the distance between the feet of the roof rack the closest. So for a bar length of 54 inches the best Rhino Rack fairing length is going to be the part #RRRF3 which measures 44…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

view full answer...

Answer 10

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 11

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 12

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Roof Rack Fit for 2012 Kia Soul with Naked Roof

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching