Will An Anti-Sway Friction Bar Work With a 6 Inch Rise Ball Mount?  

When using the Reese Sway-Control Bracket for 2" Ball Mounts part #RP26003 and the Curt Friction Sway Control for Weight Distribution Systems part #17200 together will be perfectly acceptable. It puts a slight side ways force on it but it…

As long as your owner's manual for your 2018 Volkswagen Atlas doesn't shoot down a sway-control device then you can definitely use one. Most manufacturers don't say anything about a sway control device because those tend to…

Thanks for reaching out! What size tire (located on sidewall) is currently on your 2022 Colman Lantern 263BH and what wheel bolt pattern do you have? I tried finding those specs but they aren't readily available anywhere. If you have a…

Friction sway control bars are designed to work fine going forward when turning or not but not designed to turn when backing up (backing up straight is fine). It can and likely will damage them because apparently the force being applied to them is…

We have actually spoken with Ventline regarding your model AS-13 M-VD0449 in the past and they have confirmed that the correct replacement cover is the part #BVD0449-A03 in Smoke or #BVD0449-A01 in White. The cover measures 14 inches x 14 inches and…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…

I just checked with my contact at Curt. The Curt True Course #C94VV does not have a provision for the user to adjust its sensitivity. The True Course is more for emergency maneuvers, high winds, semi trucks passing and so on. It is not necessarily…

Those are some good questions, and we'll start with if the brake lights will flash during activation using the Curt True Course Advanced Bluetooth Trailer Sway Control #C94VV. The answer to that is no, they will not flash when the True Course is…