Dexter Trailer Springs Over-Under Conversion Kit Fit Recommendation for 7k Dexter Axle

Question

Question:

I have 7000lbs Dexter axles with 2inch wide springs, does Dexter have an Over-Under Conversion Kit? Thanks

asked by: Thomas R

0

Expert Reply:

Your Dexter 7k axles would be 3 inch diameter axles so the Over-Under kit part # K71-385-00 would be the correct kit to use for your trailer.

expert reply by: Jameson C

0

Answer 1

If your trailer has an adjustable coupler and you have already tried adjusting it to the proper height for towing level, then you could install a cost effective over-under conversion kit on your trailer. Keep in mind that changing your trailer…

view full answer...

Answer 2

I do not know the propane line you have to know if you can use it, but I can tell you the correct hose for the Camco Olympian Wave 6 Catalytic Safety Heater for Small RVs #CAM57341. What you will need to use is the Camco Low-Pressure LP Gas Regulator…

view full answer...

Answer 3

The Dexter Trailer Springs Over-Under Conversion Kit #K71-385-00 referenced in your question will only work on 3 inch round axles. We do not have a kit like this available for a 4 inch diameter axle. If you are looking to raise your trailer the next…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 11

For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…

view full answer...

Answer 12

The spring hanger placement is going to be determined by your axle spacing. For example, if your axles are spaced 33 inches apart, as shown in the attached diagram, a 7K axle slipper spring, like #e74SR, requires a distance of 28-1/2 inches between…

view full answer...