How Far Out Past Rear Bumper Does Opening of Draw Tite Hitch 75087 Sit
Question:
Do you know how far from the vehicle this will stick out? I have a custom bumper cover over the back and I dont know if it will fit underneath it or not.
asked by: Tim S
0
Expert Reply:
When we installed the Draw Tit Hitch part# 75087 on a 2003 Mercedes M Class we found that the hitch pin hole stuck out the exact same distance as the furthest point out on the rear bumper. So that means the hitch opening itself would stick out 2-1/2 inches past the rear bumper.
expert reply by:
Jameson C
0
Products Referenced in This Question
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 500 lbs WD TW
- No Cross Tube
- Draw-Tite
more information >
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 500 lbs WD TW
- No Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Replacement Center Section for B&W Turnoverball Gooseneck Hitch BWGNRK1111
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Mounting Hole Distances For Curt Trailer Hitch Receiver # 13018
- Article: Determining Trailer Tongue Weight
- Q&A: What All Is Needed To Install The Curt 13018 Hitch On A 1999 Mercedes-Benz ML430
- Article: Performance Chips and Modules
- Q&A: Valterra Replacement Waste Gate Valves, 3 & 1-1/2
- Q&A: What do Trailer Acronyms GTW and TW Mean
- Q&A: Stabilization Strap for Curt Trailer Hitch # 13018 on a 1999 Mercedes ML430
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Brake Controller Installation: Starting from Scratch