Will Swagman Roamer LT Roof Rack Fit Viking Pop Up with AC

Question

Question:

will this system work with a viking campingworld series pop-up with roof AC?

asked by: Brian

0

Expert Reply:

The Swagman Roamer LT Roof Rack for Pop-Up Campers and Camper Shells # S80510 that you referenced can basically fit any pop up that doesn't have a plastic 1-piece top so it would work well for yours and would just require you to position the bars before or after the AC unit.

expert reply by: Jameson C

0

Answer 1

After you drill into your camper to install the Swagman Roamer LT Roof Rack for Pop-Up Campers and Camper Shells #S80510, there are three things that will go underneath (on the inside) of the camper: the metal plate, a washer, and a nut. As far as…

view full answer...

Answer 2

First, if your camper has a plastic, 1 piece top then this roof rack should not be used. But most campers have a more sturdy roof than that so should not have a problem with that. The hardware used to secure the rack to the roof is fairly long as…

view full answer...

Answer 3

According to the installation instructions which I've linked, the included lag bolts will work as long as there is a piece of structure under the location where you've drilled the hole. Otherwise, they recommend using the provided 6mm x 80mm…

view full answer...

Answer 4

The Swagman Roamer LT Roof Rack, part #S80510 is compatible with the Coleman Taos. Please verify with your owner's manual prior to installation both the roof capacity and that it is not a single piece, ABS roof. From my research it appears at…

view full answer...

Answer 5

Yes, the Swagman Roamer roof rack part number #S80510 that you referenced is compatible with Thule bike racks that are designed to fit square bars.

view full answer...

Answer 6

The Swagman Upright Bike Rack for 1 Bike #S64720 has U-bolt mounting holes running down the center of the entire wheel tray allowing the rack to attach to a maximum crossbar spread of 52" (from center to center of the crossbars). This means you…

view full answer...

Answer 7

I do have an option for you but you cannot use multiple hitch adapters together like the dual hitch adapter part #D-192 and the hitch extender part #C45791 for example. This would create too weak of a connection point and would limit your towing…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Yes, the Roamer LT Roof Rack for Pop-Up Campers and Camper Shells #S80510 will fit your 2023 Forest River Flagstaff 176LTD. It is also what I recommend to add a roof rack for a bicycle carrier on your camper. Once installed you will be able to add…

view full answer...

Answer 11

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

Answer 12

By "mobile home type bolt pattern" I believe you are talking about a 5 spoke utility bolt pattern such as what is on the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles #8-174-5UC3. To measure your axle from hub face to…

view full answer...