Load Range and Weight Capacity for Provider Trailer Tire TR225LRE

Question

Question:

What is the full load index and Letter Should be something like 117....

asked by: Jorg S

0

Expert Reply:

The Provide Tire part # TR225LRE is a Load Range E tire that has a capacity of 2,830 lbs at 80 psi. Unlike most trailer tires this has an 81 mph speed rating which is much higher than most tires that are 65 mph rated.

expert reply by: Jameson C

0

Answer 1

If your Carson trailer uses a standard spindle, you will need the Dexter Trailer Hub Assembly, #84550BX. This hub assembly includes lug nuts, L68149 inner bearing and race, L44649 outer bearing and race, grease cap and grease seal. If you have a…

view full answer...

Answer 2

Since you have a brake mounting flange on your boat trailer you could pretty easily install brakes on the trailer. Most likely the mounting flange is a 4 bolt flange (all 4 bolt flanges are the same), since your trailer is most likely not too heavy…

view full answer...

Answer 3

For your spindle, I definitely recommend replacing the zerk fitting and not the entire spindle. Welding a replacement spindle requires a really steady hand of an experienced welder. The Dexter Axle EZ-Lube fittings is a standard 1/4 inch pipe thread…

view full answer...

Answer 4

I went to our warehouse and pulled a couple of the Dexter Hub And Drum Assemblies, part #84556UC3. I took measurements between the bolts on the drums and took a photo you can check out. The measurement I got was 2.997 as the photo shows on the…

view full answer...

Answer 5

If a trailer tire and wheel each have different weight capacities then the lower-rated item of the two determines the overall capacity of the combination. You can certainly run a tire with a lower or higher weight rating than the wheel its used on…

view full answer...

Answer 6

The special trailer (ST type) tires that we offer in your 225/75-15 size have either a 6-ply, 8-ply or 10-ply rating. The tire you referenced #AM1ST96 is an 8-ply but in 10-ply we have the following Load Range E tires that are "10PR" like…

view full answer...

Answer 7

The wheel studs shearing off normally is caused by over tightening the lugs or your wheels have elongated holes which allow the wheel to have excess movement while traveling. The 1/2" wheel studs need about 90-100 lbs of torque. The 5/8"…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Load Range and Weight Capacity for Provider Trailer Tire TR225LRE

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching