Replacement Fulton Dual-Wheel Trailer Jack for Boat Trailer

Question

Question:

NEED SOME ADVICE ON SO MANY OF THE JACKS YOU ALL HAVE,,I NEED ONE PREFERABLY THE DUAL WHEEL FULTON, BUT I HAVE THE PLATE ALREADY WELDED ON MY TRAILER FROM THE FACTORY. SENT PIC OF MY CURRENT SETUP.......PLEASE ADVISE........THANKS

asked by: DANNY H

0

Expert Reply:

I suggest the Fulton dual-wheel Bolt-Thru Swivel Marine Jack # FXPD15L rated for 1500-lbs. This jack offers 12-inches of lift and features dual 6-inch wheels for easier handling on softer surfaces. In the event that this jack does not fit your mounting plate you can still install it using the included frame clamps that fit 3 x 5 trailer frames.

expert reply by: Adam R

0

click to enlarge

Answer 1

The 1500-lb-rated Fulton Bolt-Thru Swivel Marine Jack #F1411300301 is a great choice to replace your Triton trailer's jack. You just want to make sure your jack mounting plate looks like part #P9012-00 which provides a bolt-thru installation. If…

view full answer...

Answer 2

Without knowing the part number and manufacturer of your current trailer jack, I couldn't speak to the compatibility of the mounting plate for your current jack with the mount that the Fulton #F141132 XLT uses. The #P9012-00 weld-on mount for the…

view full answer...

Answer 3

I can't see any part numbers or manufacturer names from your picture, but the Fulton XLT #F141132 does look very similar. I went out to the warehouse and measured the bracket that the bolt, washer, and nut go through for the installation. The…

view full answer...

Answer 4

According to my contact at Fulton the correct replacement hardware kit to mount their F2 swivel jack to their adapter kit #F500320 is indeed the item you referenced, part #F0933325S00.

view full answer...

Answer 5

If you measure the distance between the mounting holes on the bracket you have on your trailer, and they do not match the mounting holes on your F2 jack you may need to have the old bracket removed and use a mounting bracket like part #F500277 for…

view full answer...

Answer 6

The only trailer jack that will work with your existing mounting bracket and not contact the boat with a full rotation of the handle is the Fulton Bolt-Thru Swivel Marine Jack part #F1411300301. I understand this does not have the sharkskin coating…

view full answer...

Answer 7

Does the welded on bracket on your trailer look like the part #P9012-00? If so, then you would want the part #F141132 for a Fulton XLT jack that would bolt right up to your trailer. If not, then you could pretty easily remove the bracket and install…

view full answer...

Answer 8

Fulton bolt-through trailer jack #F1411300301 is the only Fulton jack that mounts using that 1 center bolt. Since your old jack was a Fulton it must either be this same jack or an earlier model but they use the same mount. The mount in question and…

view full answer...

Answer 9

The capacity of the jack you choose needs to be greater than the tongue weight of the fully loaded and ready to tow trailer. I have linked you to an article that explains some methods of determining your trailer tongue weight. It's a good…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Replacement Fulton Dual-Wheel Trailer Jack for Boat Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching