Distance from Mounting Bracket to Bottom of Handle on Bulldog Jack BD1550101344

Question

Question:

What is the clearance from the bottom of the mounting bracket to the bottom of the handle when the handle is at its lowest point of the arc?

asked by: David D

1

Helpful Expert Reply:

The distance from the bottom of the mounting plate to the bottom of the handle when it is in it's lowest position is 5.1 inches.

expert reply by: Jameson C

1

click to enlarge

Answer 1

You would choose a side wind or top wind jack based on several factors. Each has its advantages. If clearance is an issue for the radius of a top wind, then you would choose a side wind. The opposite is also true. It is my experience that a side…

view full answer...

Answer 2

You will need to choose a jack whose capacity exceeds the fully loaded and ready to tow tongue weight of your trailer. Typically trailer tongue weight is 10-15 percent of the weight of the trailer. This means that when loaded to maximum, your…

view full answer...

Answer 3

The difference between top wind and sidewind is really mainly about personal preference and somewhat about clearance. Basically which way to you want to crank the jack? Horizontally or vertically? Based on your picture you'd easily be able to…

view full answer...

Answer 4

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 5

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 6

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 7

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 8

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 9

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 10

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 11

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Answer 12

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Distance from Mounting Bracket to Bottom of Handle on Bulldog Jack BD1550101344

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching