Availability of Extra Mounting Plates for Ultra-Fab # UF48-979013 Skid Wheel

Question

Question:

I ordered skid wheels PN UF48-979013 based on your recommendation. Due to installation/mounting issues to the frame had to add spacers in order to get the proper height, I used both mounting plates on one wheel. How can I purchase two additional mounting plates?

asked by: Carlos L

0

Expert Reply:

Unfortunately, Ultra-Fab receives the # UF48-979013 skid wheels already in the retail packaging directly from the manufacturer. Therefore, the mounting plates aren't available separately. A local metal fabricating shop could easily make a few more up for you.

expert reply by: Mike L

0

Answer 1

The Trailer Hub and Drum Assembly part #AKHD-545-35-K is the correct replacement for an AL-KO 7230. In regards to the braking assemblies, I suggest getting a new pair, the Electric Trailer Brake Kit part #AKEBRK-35-SA. This option will save you some…

view full answer...

Answer 2

Another wire or harness is not needed on the 2023 Honda CR-V for the install of the Curt 4-Way Wiring Harness #C56370, but you do have to add 20 amp fuse to location #17 in the fuse box.

view full answer...

Answer 3

I do have an option for you but the Curt Trailer Hitch Receiver part #13390 on your 2015 Subaru Legacy already has the highest ground clearance (10-1/4") of any other trailer hitch receiver we have confirmed to fit your vehicle. This measurement…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 6

For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…

view full answer...

Answer 7

The spring hanger placement is going to be determined by your axle spacing. For example, if your axles are spaced 33 inches apart, as shown in the attached diagram, a 7K axle slipper spring, like #e74SR, requires a distance of 28-1/2 inches between…

view full answer...

Answer 8

I attached a picture that shows the proper position of shackles and equalizers on trailer suspension. Sometimes the shackle will flip up but if you jack up the trailer by the axle that's got the shackle flipped you can usually get it to flip back…

view full answer...