Hitch Recommendation for a 2009 Nissan Versa Hatchback

Question

Question:

will this hitch also work on a 2009 model nissan versa hatchback? just need it to pull a small light trailer occasionally? thanks

asked by: dwain p

0

Expert Reply:

Yes, the Curt Trailer Hitch for the 2009 Nissan Versa part # 11348, will fit on your 2009 Nissan Versa Hatchback.

This hitch is a Class I hitch and has a 200 lb tongue weight limit and a 2,000 lb gross trailer weight, as long as your trailer is under those limits this hitch should work great. You will also want to check the manufacturers towing recommendations for your Versa, so you will not exceed the weight that your vehicle should tow.

Here are a few other items you may need to complete your towing setup:

Trailer Wiring # 119176
Hitch Lock # 1480DAT
Ball Mount # C45520
Hitch Ball # C40001 or # C40018

expert reply by: Jameson C

0

Answer 1

It isn't a question of legality so legally, yes, you could install a hitch and tow the small boat and trailer with your 2007 Nissan Versa. If you were to take the vehicle in for warranty work and they saw the hitch they could say that it voids…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...