Which SuperTruss Extension Is Needed for 30 inches from Vehicle Bumper to Camper Bumper

Question

Question:

I was just wondering whether to go with a longer or shorter one as my distance from bumper on truck to bumper on camper is 30?

asked by: John C

0

Expert Reply:

That would depend a lot on the shape of the nose of your trailer, but if it's a standard trailer with a decent amount of clearance between the coupler and where the rest of the trailer starts the part # TLE1524 that provides 24 inches of clearance would work just fine.

Otherwise a 32 inch long part # TLE1532 would be a better choice if clearances are tight on the front of your trailer.

expert reply by: Jameson C

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 5

We do offer hitch extensions for the factory 3" trailer hitch receiver on your 2017 Ford F-350 Super Duty, but there is not one that is 24" long. The shortest extension available is the TorkLift Cannon Hitch Extension - 3" Ford Super…

view full answer...

Answer 6

The proper extension for your setup would be the one that allows you to have clearance of your hitch mounted accessory and also allows you to still be able to pull the steps down. If the receiver tube sticks out past the camper too far then you will…

view full answer...

Answer 7

From end to end, the extendable arm measures 30-5/16 inches for the Kuat Pivot 2 Swing Away Hitch Extender for Bike Racks - 2" Hitches - Driver's Side #PVD20B.

view full answer...

Answer 8

The hitch opening location for the Torklift Hitch part #TLF1002-30 that you referenced will be very close to where you current hitch opening is. If the 28 extension part #TLE1528 would work well based on your current measurements it would be a great…

view full answer...

Answer 9

When determine if you can fully open swing-out doors on your 2022 ProMaster 3500 with the Yakima EXO #Y34ZR, it really depends on how far your doors swing when in the open position. While the 90-degree swing has not been tested spcificially on a 2022…

view full answer...

Answer 10

If you have the Ford 3" hitch then you can definitely add it but, yes it would change the weight capacity. The TorkLift Cannon Hitch Extension item #TLE1636 only has a 3,600 lbs towing capacity and a 360 lbs maximum tongue weight. If used with a…

view full answer...

Which SuperTruss Extension Is Needed for 30 inches from Vehicle Bumper to Camper Bumper

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching