Replacement Strap Recommendation to Replace Thule 853-5831

Question

Question:

Looking to replace damaged straps on a Thule 4 bike carrier, hitch type. Unable determine rack model number. Straps have p/n 853-5831 molded in, but searching for that p/n gives no results, no x-refs to superseding p/n. Existing strap has 8 holes: 1 rectangular to attach to cradle, then 1 large round to go around cradle support arm bar, then 6 smaller round holes to attach to opposite side of cradle. Is there a strap replacement without replacing cradle? Thanks for your help!

asked by: Ted L

1

Helpful Expert Reply:

It looks like Thule switched to strap # 753-3535 for many bike racks as a replacement for the 853-5831 that you have.

expert reply by: Jameson C

1

Answer 1

Though this does look remarkable similar to the Thule Hitching Post Pro #TH934XTR, to my knowledge this rack was never offered with just a 2" shank as it used a 1-1/4" shank with a 2" adapter, so I can't say exactly…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The hole in the yellow octagon is offset from the center which when installed in the slotted hanger like the part #LC303918 gives you the ability to set an exact alignment with the other sides hanger but using the same configuration by simply…

view full answer...

Answer 5

The inner diameter of the Replacement Hold Fast Cradle #852-3005-002 is 1-1/4 inches.

view full answer...

Answer 6

The fittings of the MB Sturgis Sturgi-Stay T-Fitting w/ Hose for POL Valve #103609-MBS do not require any teflon tape when installing. They have rubber gaskets built into them to provide the seal.

view full answer...

Answer 7

If you live in an area where it is currently cold (since this is February) then the issue is that the rubber strap like part #753-3535 are being difficult to stretch due to the cold. Try heating the rubber straps up a little by taking the bike rack…

view full answer...

Answer 8

I checked with Thule for you and we do have the replacement parts for your Thule Helium Aero bike rack, though keep in mind the whole cradle is not available, just the cradle overmold (the top part); what you need is the following: - Replacement…

view full answer...

Answer 9

I called Thule and they confirmed the correct strap for your Thule spare Me 963XT is the Replacement Rubber Strap T2 Bike Carrier Cradles #753-3535. The Replacement Straps for Cradles on Thule Bike Racks #TH534 is not a fit your Thule Spare Me 963XT…

view full answer...

Answer 10

It looks like you purchased the Thule T3 Cradle, #853-5829, and the T3 Strap, #753-3535. These two items should work well together so I made a short demonstration video for you. If you think you may have received a different strap or are missing a…

view full answer...

Replacement Strap Recommendation to Replace Thule 853-5831

Product Page this Question was Asked From

Continue Researching